Scribd
Upload
305 views2 pages

Using A Micrometer Screw

The document describes how to use a micrometer screw-gauge to measure the diameter of a wire. You place the wire between the anvil and spindle end of the micrometer. Rotating the thimble holds the wire firmly in place. To take a reading, read the main scale in millimeters first and then the rotating scale which provides measurements to the hundredth of a millimeter. The diameter measurement is the sum of the two scale readings. With experience, measurements can be read to within 0.005mm, but +/- one division is more realistic. Always check for a zero error before using the micrometer.

Uploaded by

Carole Thami
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
305 views2 pages

Using A Micrometer Screw

The document describes how to use a micrometer screw-gauge to measure the diameter of a wire. You place the wire between the anvil and spindle end of the micrometer. Rotating the thimble holds the wire firmly in place. To take a reading, read the main scale in millimeters first and then the rotating scale which provides measurements to the hundredth of a millimeter. The diameter measurement is the sum of the two scale readings. With experience, measurements can be read to within 0.005mm, but +/- one division is more realistic. Always check for a zero error before using the micrometer.

Uploaded by

Carole Thami
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd

Using a Micrometer Screw-Gauge

You can use a mircometer to measure small (>2.5 cm) diameters that can fit within the 'jaws' of the screwgauge

Determination of the diameter 'd' of a wire

Place the wire between the anvil and spindle end as indicated in the diagram.
Rotate the thimble until the wire is firmly held between the anvil and the spindle.
The rachet is provided to avoid excessive pressure on the wire. It prevents the spindle from further
movement - squashing the wire!.
To take a reading:
First look at the main scale. This has a linear scale reading on [Link] long
lines are every millimetre the shorter ones denote half a millimetre in

between.
On the diagram this reading is 2.5 mm
Now look at the rotating scale. That denotes 46 divisions - each division is 0.01mm so we have 0.46mm
from this scale.

The diameter of the wire is the sum of these readings: 2.5 + 0.46 = 2.96 mm
Sensitivity of the reading
You can read to half a rotating scale division - to within 0.005mm - but no more than that. That assumes you
have experience and confidence in using the instument +/- one division is more realistic!
Practical Notes
SWG (Standard Wire Gauge) 32 wire has a manufacturer diameter value of 0.274 mm. If you measure
it with a micrometer in school you could only say it was 0.275mm - that last digit of '4' would be
impossible to measure with a micrometer.
Always check carefully for a zero error before using the micrometer!
Here is a vid clip with an animation that takes you through how the morcometer works and how to
read it.

This vid clip shows how use larger mircometers, how to check the accuracy of an instrument before you use
it and also the range of micrometers you can get. (You need to go to You Tube to see it as I can't embed it).
v

You might also like