Scribd
Upload
135 views2 pages

Node Voltage Analysis Methods

This document discusses two methods for writing node equations to solve for the node voltages (va and vb) in a circuit containing a voltage source. Method 1 involves labeling the voltage source current, writing KCL equations at each node, and eliminating the current to obtain a single equation relating va and vb. Method 2 applies KCL to a "supernode" encompassing the voltage source, arriving at the same equation. Both methods yield the node equations vb - va = 12 and va/6 + vb/3 = -2, which can be solved to find va = -12 V and vb = 0 V.

Uploaded by

Salekin Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
135 views2 pages

Node Voltage Analysis Methods

This document discusses two methods for writing node equations to solve for the node voltages (va and vb) in a circuit containing a voltage source. Method 1 involves labeling the voltage source current, writing KCL equations at each node, and eliminating the current to obtain a single equation relating va and vb. Method 2 applies KCL to a "supernode" encompassing the voltage source, arriving at the same equation. Both methods yield the node equations vb - va = 12 and va/6 + vb/3 = -2, which can be solved to find va = -12 V and vb = 0 V.

Uploaded by

Salekin Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Example

Determine the values of the node voltages, va and vb, for this circuit.

Solution
We can write one node equation by considering the voltage source. The voltage source voltage is
related to the node voltages at by
v b v a = 12 v b = v a + 12

In order to write the second node equation, we must decide what to do about the voltage source
current. (Notice that there is no easy way to express the voltage source current in terms of the
node voltages.) In this example, illustrate two methods of writing the second node equation.
Method 1: Assign a name to the voltage source current. Apply KCL at both of the voltage
source nodes. Eliminate the voltage source current from the KCL equations.
Heres the circuit after labeling the voltage source current.

The KCL equation at node a is


1.5 + i =

va
6

The KCL equation at node b is


i + 3.5 +
Combining these two equations gives

vb
3

=0

vb va

1.5 3.5 + =
3 6

2.0 =

va
6

vb
3

Method 2: Apply KCL to the supernode corresponding to the voltage source. Shown below in
blue, this super node separates the voltage source and its nodes from the rest of the circuit. (In
this small circuit, the rest of the circuit is just the reference node.)

Apply KCL to the supernode to get


1.5 =

va
6

+ 3.5 +

vb

2.0 =

va
6

vb
3

This is the same equation that was obtained using method 1. Applying KCL to the supernode is a
shortcut for doing three things:
1. labeling the voltage source current as i
2. applying KCL at both nodes of the voltage source
3. eliminating i from the KCL equations

In summary, the node equations are


v b v a = 12

and
va
6

vb
3

= 2.0

Solving the node equations gives


v a = 12 V

and

vb = 0 V

(We might be surprised that v b is 0 V but it is easy to check that these values are correct by
substituting them into the node equations.)

You might also like