Electrical generator

From Wikipedia, the free encyclopedia

Jump to: navigation, search

NRC image of Modern Steam Turbine Generator.

In electricity generation, an electrical generator is a device that converts mechanical energy to

electrical energy. The reverse conversion of electrical energy into mechanical energy is done by
a motor; motors and generators have many similarities. A generator forces electric charges to
move through an external electrical circuit, but it does not create electricity or charge, which is
already present in the wire of its windings. It is somewhat analogous to a water pump, which
creates a flow of water but does not create the water inside. The source of mechanical energy
may be a reciprocating or turbine steam engine, water falling through a turbine or waterwheel, an
internal combustion engine, a wind turbine, a hand crank, compressed air or any other source of
mechanical energy.

Early 20th century alternator made in Budapest, Hungary, in the power generating hall of a
hydroelectric station
Generator in Zwevegem, West Flanders, Belgium
Contents
[hide]

 1 Historical developments
o 1.1 Jedlik's dynamo
o 1.2 Faraday's disk
o 1.3 Dynamo
o 1.4 Other rotating electromagnetic generators
o 1.5 MHD generator
 2 Terminology
 3 Excitation
 4 Equivalent circuit
 5 Vehicle-mounted generators
 6 Engine-generator
 7 Human powered electrical generators
 8 See also
 9 References
 10 External links

[edit] Historical developments

Before the connection between magnetism and electricity was discovered, electrostatic
generators were invented that used electrostatic principles. These generated very high voltages
and low currents. They operated by using moving electrically charged belts, plates and disks to
carry charge to a high potential electrode. The charge was generated using either of two
mechanisms:

 Electrostatic induction
 The triboelectric effect, where the contact between two insulators leaves them charged.

Because of their inefficiency and the difficulty of insulating machines producing very high
voltages, electrostatic generators had low power ratings and were never used for generation of
commercially-significant quantities of electric power. The Wimshurst machine and Van de
Graaff generator are examples of these machines that have survived.

[edit] Jedlik's dynamo

Main article: Jedlik's dynamo

In 1827, Hungarian Anyos Jedlik started experimenting with electromagnetic rotating devices
which he called electromagnetic self-rotors. In the prototype of the single-pole electric starter
(finished between 1852 and 1854) both the stationary and the revolving parts were
electromagnetic. He formulated the concept of the dynamo at least 6 years before Siemens and
Wheatstone but didn't patent it as he thought he wasn't the first to realize this. In essence the
concept is that instead of permanent magnets, two electromagnets opposite to each other induce
the magnetic field around the rotor. Jedlik's invention was decades ahead of its time.[citation needed]

[edit] Faraday's disk

Faraday disk

In the years of 1831-1832 Michael Faraday discovered the operating principle of electromagnetic
generators. The principle, later called Faraday's law, is that a potential difference is generated
between the ends of an electrical conductor that moves perpendicular to a magnetic field. He also
built the first electromagnetic generator, called the 'Faraday disk', a type of homopolar generator,
using a copper disc rotating between the poles of a horseshoe magnet. It produced a small DC
voltage.

This design was inefficient due to self-cancelling counterflows of current in regions not under
the influence of the magnetic field. While current flow was induced directly underneath the
magnet, the current would circulate backwards in regions outside the influence of the magnetic
field. This counterflow limits the power output to the pickup wires, and induces waste heating of
the copper disc. Later homopolar generators would solve this problem by using an array of
magnets arranged around the disc perimeter to maintain a steady field effect in one current-flow
direction.

Another disadvantage was that the output voltage was very low, due to the single current path
through the magnetic flux. Experimenters found that using multiple turns of wire in a coil could
produce higher more useful voltages. Since the output voltage is proportional to the number of
turns, generators could be easily designed to produce any desired voltage by varying the number
of turns. Wire windings became a basic feature of all subsequent generator designs.

However, recent advances (rare earth magnets) have made possible homo-polar motors with the
magnets on the rotor, which should offer many advantages to older designs.

[edit] Dynamo

Main article: Dynamo

Dynamos are no longer used for power generation due to the size and complexity of the
commutator needed for high power applications. This large belt-driven high-current dynamo
produced 310 amperes at 7 volts, or 2,170 watts, when spinning at 1400 RPM.

Dynamo Electric Machine [End View, Partly Section] (U.S. Patent 284,110)

The Dynamo was the first electrical generator capable of delivering power for industry. The
dynamo uses electromagnetic principles to convert mechanical rotation into a pulsing direct
electric current through the use of a commutator. The first dynamo was built by Hippolyte Pixii
in 1832.
Through a series of accidental discoveries, the dynamo became the source of many later
inventions, including the DC electric motor, the AC alternator, the AC synchronous motor, and
the rotary converter.

A dynamo machine consists of a stationary structure, which provides a constant magnetic field,
and a set of rotating windings which turn within that field. On small machines the constant
magnetic field may be provided by one or more permanent magnets; larger machines have the
constant magnetic field provided by one or more electromagnets, which are usually called field
coils.

Large power generation dynamos are now rarely seen due to the now nearly universal use of
alternating current for power distribution and solid state electronic AC to DC power conversion.
But before the principles of AC were discovered, very large direct-current dynamos were the
only means of power generation and distribution. Now power generation dynamos are mostly a
curiosity.

[edit] Other rotating electromagnetic generators

Without a commutator, the dynamo is an example of an alternator, which is a synchronous

singly-fed generator. With an electromechanical commutator, the dynamo is a classical direct
current (DC) generator. The alternator must always operate at a constant speed that is precisely
synchronized to the electrical frequency of the power grid for non-destructive operation. The DC
generator can operate at any speed within mechanical limits but always outputs a direct current
waveform.

Other types of generators, such as the asynchronous or induction singly-fed generator, the
doubly-fed generator, or the brushless wound-rotor doubly-fed generator, do not incorporate
permanent magnets or field windings (i.e, electromagnets) that establish a constant magnetic
field, and as a result, are seeing success in variable speed constant frequency applications, such
as wind turbines or other renewable energy technologies.

The full output performance of any generator can be optimized with electronic control but only
the doubly-fed generators or the brushless wound-rotor doubly-fed generator incorporate
electronic control with power ratings that are substantially less than the power output of the
generator under control, which by itself offer cost, reliability and efficiency benefits.

[edit] MHD generator

A magnetohydrodynamic generator directly extracts electric power from moving hot gases
through a magnetic field, without the use of rotating electromagnetic machinery. MHD
generators were originally developed because the output of a plasma MHD generator is a flame,
well able to heat the boilers of a steam power plant. The first practical design was the AVCO
Mk. 25, developed in 1965. The U.S. government funded substantial development, culminating
in a 25MW demonstration plant in 1987. In the Soviet Union from 1972 until the late 1980s, the
MHD plant U 25 was in regular commercial operation on the Moscow power system with a
rating of 25 MW, the largest MHD plant rating in the world at that time.[1] MHD generators
operated as a topping cycle are currently (2007) less efficient than combined-cycle gas turbines.

[edit] Terminology

Rotor from generator at Hoover Dam, United States

The two main parts of a generator or motor can be described in either mechanical or electrical
terms:[2]

Mechanical:

 Rotor: The rotating part of an electrical machine

 Stator: The stationary part of an electrical machine

Electrical:

 Armature: The power-producing component of an electrical machine. In a generator,

alternator, or dynamo the armature windings generate the electrical current. The armature
can be on either the rotor or the stator.
 Field: The magnetic field component of an electrical machine. The magnetic field of the
dynamo or alternator can be provided by either electromagnets or permanent magnets
mounted on either the rotor or the stator.

Because power transferred into the field circuit is much less than in the armature circuit, AC
generators nearly always have the field winding on the rotor and the stator as the armature
winding. Only a small amount of field current must be transferred to the moving rotor, using slip
rings. Direct current machines necessarily have the commutator on the rotating shaft, so the
armature winding is on the rotor of the machine.

[edit] Excitation
A small early 1900s 75 KVA direct-driven power station AC alternator, with a separate belt-
driven exciter generator.
Main article: Excitation (magnetic)

An electric generator or electric motor that uses field coils rather than permanent magnets will
require a current flow to be present in the field coils for the device to be able to work. If the field
coils are not powered, the rotor in a generator can spin without producing any usable electrical
energy, while the rotor of a motor may not spin at all. Very large power station generators often
utilize a separate smaller generator to excite the field coils of the larger.

In the event of a severe widespread power outage where islanding of power stations has
occurred, the stations may need to perform a black start to excite the fields of their largest
generators, in order to restore customer power service.

[edit] Equivalent circuit

Equivalent circuit of generator and load.

G = generator
VG=generator open-circuit voltage
RG=generator internal resistance
VL=generator on-load voltage
RL=load resistance

The equivalent circuit of a generator and load is shown in the diagram to the right. To determine
the generator's VG and RG parameters, follow this procedure: -
  Before starting the generator, measure the resistance across its terminals using an
ohmmeter. This is its DC internal resistance RGDC.
 Start the generator. Before connecting the load RL, measure the voltage across the
generator's terminals. This is the open-circuit voltage VG.
 Connect the load as shown in the diagram, and measure the voltage across it with the
generator running. This is the on-load voltage VL.
 Measure the load resistance RL, if you don't already know it.
 Calculate the generator's AC internal resistance RGAC from the following formula:

Note 1: The AC internal resistance of the generator when running is generally slightly higher
than its DC resistance when idle. The above procedure allows you to measure both values. For
rough calculations, you can omit the measurement of RGAC and assume that RGAC and RGDC are
equal.

Note 2: If the generator is an AC type, use an AC voltmeter for the voltage measurements.

The maximum power theorem states that the maximum power can be obtained from the
generator by making the resistance of the load equal to that of the generator. This is inefficient
since half the power is wasted in the generator's internal resistance; practical electric power
generators operate with load resistance much higher than internal resistance, so the efficiency is
greater.

[edit] Vehicle-mounted generators

Early motor vehicles until about the 1960s tended to use DC generators with electromechanical
regulators. These have now been replaced by alternators with built-in rectifier circuits, which are
less costly and lighter for equivalent output. Automotive alternators power the electrical systems
on the vehicle and recharge the battery after starting. Rated output will typically be in the range
50-100 A at 12 V, depending on the designed electrical load within the vehicle. Some cars now
have electrically-powered steering assistance and air conditioning, which places a high load on
the electrical system. Large commercial vehicles are more likely to use 24 V to give sufficient
power at the starter motor to turn over a large diesel engine. Vehicle alternators do not use
permanent magnets and are typically only 50-60% efficient over a wide speed range.[3]
Motorcycle alternators often use permanent magnet stators made with rare earth magnets, since
they can be made smaller and lighter than other types. See also hybrid vehicle.

Some of the smallest generators commonly found power bicycle lights. These tend to be 0.5
ampere, permanent-magnet alternators supplying 3-6 W at 6 V or 12 V. Being powered by the
rider, efficiency is at a premium, so these may incorporate rare-earth magnets and are designed
and manufactured with great precision. Nevertheless, the maximum efficiency is only around
80% for the best of these generators - 60% is more typical - due in part to the rolling friction at
the tire-generator interface from poor alignment, the small size of the generator, bearing losses
and cheap design.

Sailing yachts may use a water or wind powered generator to trickle-charge the batteries. A small
propeller, wind turbine or impeller is connected to a low-power alternator and rectifier to supply
currents of up to 12 A at typical cruising speeds.

[edit] Engine-generator
Main article: Engine-generator

An engine-generator is the combination of an electrical generator and an engine (prime mover)

mounted together to form a single piece of self-contained equipment. The engines used are
usually piston engines, but gas turbines can also be used. Many different versions are available -
ranging from very small portable petrol powered sets to large turbine installations.

[edit] Human powered electrical generators

Main article: Self-powered equipment

A generator can also be driven by human muscle power (for instance, in field radio station
equipment).

Human powered direct current generators are commercially available, and have been the project
of some DIY enthusiasts. Typically operated by means of pedal power, a converted bicycle
trainer, or a foot pump, such generators can be practically used to charge batteries, and in some
cases are designed with an integral inverter. The average adult could generate about 125-200
watts on a pedal powered generator. Portable radio receivers with a crank are made to reduce
battery purchase requirements, see clockwork radio.

[edit] See also

Wikimedia Commons has media related to: Electrical generators

Energy portal

 Faraday's law of induction

 Alternator
 Homopolar generator
 Hybrid vehicle
 Solar cell
 Radioisotope thermoelectric generator
  Thermogenerator
 Wind turbine
 Diesel generator

[edit] References
1. ^ Langdon Crane, Magnetohydrodynamic (MHD) Power Generator: More Energy from Less
Fuel, Issue Brief Number IB74057, Library of Congress Congressional Research Service, 1981,
retrieved from [Link] July 18, 2008
2. ^ James Stallcup (2005). Stallcup's Generator, Transformer, Motor And Compressor Book, 2005.
Jones & Bartlett Publishers. p. 2-1. ISBN 9780877656692. [Link]
id=OkwGeMAXJa8C&pg=PT22&dq=generator+terms+armature+rotor+stator+field+mechanical
+electrical&num=20&ei=2jTlStQBiMyVBKSpgJEM#v=onepage&q=generator%20terms
%20armature%20rotor%20stator%20field%20mechanical%20electrical&f=false.
3. ^ Horst Bauer Bosch Automotive Handbook 4th Edition Robert Bosch GmbH, Stuttgart 1996
ISBN 0-8376-0333-1, page 813