Media Search - RENR2635 - 784C, 785C, 785D, 789C, 789D, 793C, 793D, 797 and 7...
Page 1 of 2
Shutdown SIS
Previous Screen
Product: NO EQUIPMENT SELECTED
Model: NO EQUIPMENT SELECTED
Configuration: NO EQUIPMENT SELECTED
Systems Operation
784C, 785C, 785D, 789C, 789D, 793C, 793D, 797 and 797B Off-Highway Trucks
TM
VIMS and Truck Payload Measurement System (TPMS)
Media Number -RENR2635-07 Publication Date -01/12/2013 Date Updated -18/12/2013
i05603733
Truck Payload - Calibrate
SMCS - 7494; 7601
The Truck Payload Measurement System (TPMS) must be calibrated if the VIMSpc software is
used to assign a new serial number to the VIMSTM electronic control module (ECM). The TPMS
must also be calibrated after the replacement of the VIMS ECM, the suspension cylinders, and the
suspension cylinder pressure sensors.
The VIMS TPMS will not operate until a successful payload calibration has been completed.
Security
1. This service program code only functions while the VIMSpc service tool is connected.
2. After VIMSpc is disconnected for 30 seconds, this service program code will no longer be
active.
The following information describes the service program code 729225 (PAYCAL). The PAYCAL
service program code uses the following procedure to calibrate the VIMS TPMS:
1. Ensure that the truck body is empty.
Carryback weight will affect the payload measurement.
2. Operate the empty truck to a minimum ground speed of 4 mph on hard level ground.
3. Move the transmission gear selector to the neutral position and allow the truck to coast to a
stop. Do not use the service brakes or the retarder.
4. Manually calibrate the payload system by entering the service program code 729225
(PAYCAL).
One of the following two messages will now show on the message area:
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sisw... 4/11/2016
Media Search - RENR2635 - 784C, 785C, 785D, 789C, 789D, 793C, 793D, 797 and 7... Page 2 of 2
Illustration 1 g00490356
If the above message is shown, put the truck back into service.
Illustration 2 g00490360
If the above message is shown, repeat the procedure again from Step 1. Make sure that the ground
speed is at a minimum of 4 mph. Do not use the service brakes and/or the retarder.
Copyright 1993 - 2016 Caterpillar Inc. Mon Apr 11 20:51:41 UTC+0800 2016
All Rights Reserved.
Private Network For SIS Licensees.
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sisw... 4/11/2016
