Scribd
Upload
56 views12 pages

Microsoft PowerPoint - 05 - Axial-Flow Pumps and Fans

The document discusses the impact of vane thickness and camber on the performance of various airfoils, specifically NACA 4312, NACA 4306, NACA 6306, and NACA 2306. It also addresses the variation of cascade coefficient K in relation to pitch-chord ratio and stagger angle for circular arc airfoils. Additionally, it outlines a preliminary design procedure involving parameters such as flow rate, impeller tip diameter, and aspect ratio.

Uploaded by

H_AbdelMeguid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
56 views12 pages

Microsoft PowerPoint - 05 - Axial-Flow Pumps and Fans

The document discusses the impact of vane thickness and camber on the performance of various airfoils, specifically NACA 4312, NACA 4306, NACA 6306, and NACA 2306. It also addresses the variation of cascade coefficient K in relation to pitch-chord ratio and stagger angle for circular arc airfoils. Additionally, it outlines a preliminary design procedure involving parameters such as flow rate, impeller tip diameter, and aspect ratio.

Uploaded by

H_AbdelMeguid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Effect of vane thickness on airfoil performance

NACA 4312

NACA 4306
Effect of vane camber on airfoil performance.

NACA 6306

NACA 2306
Variation of cascade coefficient K for circular arc airfoil with pitch-chord
ratio and stagger angle.
pumps
fans
fans
FLOW OVER ISOLATED AIRFOIL
• Mean radius :

• pitch :

• Solidity : , pitch/chord ratio =

• Projected Area :

• Mean flow angle :

• Aspect ratio =
PRELIMINARY DESIGN PROCEDURE
• Q, (H or SP) , (N or )

• or

• The Cordier diagram  specific diameter s  impeller tip diameter Dt.

• 0.3 <  = < 0.7


PRELIMINARY DESIGN PROCEDURE
• 0.4 < 1.1 if not in the range chose another value of  =
3 !" #$%
• Aspect ratio =
3 !" &'(&%
PRELIMINARY DESIGN PROCEDURE

D/L

You might also like