Scribd
Upload
97 views2 pages

Muttom Polytechnic Exam Paper 2020

This document appears to be an exam for a structural design course, as it contains multiple choice and short answer questions testing concepts like tension members, compression members, beams, shear, welding, and design calculations. The exam is divided into three parts testing definitions, short conceptual explanations, and longer design problems. It provides the necessary codes, materials properties, and load information to solve structural analysis and design problems.

Uploaded by

sanjithr619
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
97 views2 pages

Muttom Polytechnic Exam Paper 2020

This document appears to be an exam for a structural design course, as it contains multiple choice and short answer questions testing concepts like tension members, compression members, beams, shear, welding, and design calculations. The exam is divided into three parts testing definitions, short conceptual explanations, and longer design problems. It provides the necessary codes, materials properties, and load information to solve structural analysis and design problems.

Uploaded by

sanjithr619
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd

Government Polytechnic College

Muttom, Idukki
Name.................................................... Roll No. .......................

Subject Name SDII Academic Year 2020


nd
Course Code 6013 Exam/Date II Series Test/24-02-2020
Sem/Branch S6CE Duration 1 Hour
Exam Time 10 PM TO 11PM Maximum Marks 25 Marks

PART-A (Each question carries 2 marks) Max Marks :4

Q No Marks CO Level
1 Define the term tension member.
2 2 I
2 Define Laterally supported beam.
2 3 I

PART-B (Each question carries 6 marks answer any one) Max Marks :6
Q No Marks CO Level
3 a) Define the following terms of a compression member
(i)Actual length (ii)Effective length (iii)Slenderness ratio 6 2 II

b) Explain the classification of crossection as per IS 800-2007,


based on plastic analysis. 6 3 II

OR
4 a) Write the expression for determining design strength of a
tension member (i) Due to rupture of critical section (ii)Due to 6 2 II
block shear
b) Write any six codal provision for lacing as per IS 800:2007 6 3 II
PART-C (Each question carries 15 marks answer any one) Max Marks :15
Q No Marks CO Level
5 a) A single angle ISA 90x60x6 mm thick is connected to gusset
plate of 10mm thick by fillet weld of 4mm size . Given
fy=250MPa, fu=410MPa and length of the weld is 200mm.
Determine tensile strength in yielding and rupture. 8 2 III

b) Determine the design bending moment of a laterally supported


beam ISMB350@524N/m, fy=250MPa.
7 3 III

OR
6 a) Design a single angle strut connected to gusset plate carry a 8 2 III
Factored load of 200kN. The length of the member is 3m,
fy=250MPa
b) An ISWB350@569N/m carries maximum shear force 90kN,
7 3 III
Check the beam in shear, with fy=250MPa

You might also like