Digital Ma

Digital trix Intercom Systems

Matrix
Technical Data Sheet 4WBA
4WBA
Description
FFour
our Wire
Wire
Wire
The 4 wire Buffer
Amplifier is a six
Buffer
Buffer Amplifier
Amplifier
channel, high
performance audio
line driver amplifier
with transformer- Please Contact Us
balanced inputs
and outputs. It can Telex Communications, Inc.
be used as a six 12000 Portland Avenue South
input, six output Burnsville, MN 55337 U.S.A.
group of individual Tel: (800) 392-3497
amplifiers in a 1 Fax: (800) 323-0498
RU mount. Electri-
cal isolation
between amplifiers Order Information
is sufficient to eliminate any chance of cross-talk. Each channel on the
MODEL NO. DESCRIPTION CA TALOG NO.
4WBA system has its own level control, in/output level monitoring 3-point
4WBA-6 6-Channel 9000-7767-000
LED meter, limiter, gate and VOX tally output function for Rx channel. Model

4WBA-3 3-Channel 9000-7767-001

Model

Features

• TRANSFORMER BALANCED INPUT: Each input uses two cross-coupled audio

transformers to help minimize hum and provide
galvanic isolation.

• IMPEDANCE: Input impedance selection to either 600 Ohms or

10.0 K Ohms via 3 pin jumpers.

• GAIN: -40 to +20 dBu, five step selectable and ±10dB gain
volume for Rx channel operating level. -10 to +10dBu
adjustable for TX channel operating level. Rx channel
is available for input mute position. Nominal setup
level is selectable 0dBu or -10dBu, via jumpers

• LIMITER: Threshold level is adjustable -6 to +12 dBu, via inside

trimmer.

• GATE AND VOX: Threshold level is adjustable -30 to -10dBu, via panel
trimmer. Each RX channel of VOX tally output DB25F
connector for the UIO256 GPI function.

• TRANSFORMER BALANCED OUTPUTS: Four Wire side of In/Outputs capable of driving

600 Ohm loads. Matrix site In/Output stages
transformer option.

• REDUNDANT POWER SUPPLY: Dual power supply provides redundant operationn.

Bi-color LED display and Fault LED with tarry output
to DB25F connector.
 Digital Ma
Digital trix Intercom Systems
Matrix
Specifications
Activate Warranty Temperature: 0°C-50° C (32°-122°F) 4WBA
4WBA
Power Requirement: Single Output Power Supply
+12V 2.5A/30W
(2 PS unit for Redundant)
FFour
our Wire
Wire
Wire
DC converter ±12V 0.45A
(on Board)
Buffer
Buffer Amplifier
Amplifier
AC Inputs: AC 100V to 240V ±10% Input
2 Fused AC Power Connector with Line
Filter
Input Level Adjustment Range: +30dB to -10dB and 6 step
Only RX-Ch: GAIN Range VR Adjustable Gain
+30dB +20 to +40dB
+20dB +10 to +30dB
+10dB 0 to +20dB
0dB -10 to +10dB
-10dB -20 to 0dB

Adjustable VR ranges +/- 10dB with center point for Knob Range
Maximum/Minimum Input Level: +20dB to -40dB
System Frequency Response: TXch: 50Hz~10Hz (-3dB)
RXch: 80Hz~10kHz (-3dB)
Noise Level: > -60dB (Bandwidth 30 kHz)
Distortion: >0.5% (under limiter activate point)
Frequency Range: 100Hz to 10kHz (0dBu Output)
Crosstalk: > -60dB, at 30Hz~10kHz
> -80dB, at 1kHz
CMRR: > -70dB, at 30Hz~1kHz
> -50dB, at 15kHz
Input Circuit Method: RXch - Trans Coupling
TXch - Electric Balance
* Transformer Coupling is Option
** Floating/Unfloating are selected by jumper.
*** Only RXch 600Ω Termination resister is selectable by jumper.
Maximum Output Level: Operating Level is selectable 0dBu and -10dBu by jumper.
Selected in a jumper:
In case of adjustment 0 dBu for operating level
RX 600Ω load Maximum +10dBu (1kHz)
TX 600Ω load Maximum +10dBu (1kHz)
In case of -10dBu for operating level,
Limiter is changed by 0dBu
Output Circuit Method: RXch - Electric Balance
TXch - Trans Coupling
***TX system Floating/Unfloating are selected by jumper.
Audio Gate Activate Level: -30dbu~-10dBu Adjustable Pot on Front
Audio Gate Attack Time: General audio 30mSec nominal
Audio Tally Output: @12V 50mA load operate is possible. An output is negative logic,
Mute = High
VOX = Low
Equipment for Audio Limiter Circuit: Limiter activate level ranges -6dB to +12dB. It adjusts by internal pot.
Adjustment value: +10 dBu
Signal Level Indicators: Display output level to all Ch.
>+10dBu Red LED Turn ON
> 0dBu Yellow LED Turn ON
> -20dBu Green LED Turn ON
Equipment for Audio Filter: Only audio gated ch., High Pass filter at 80Hz, Low Pass filter at 10kHz

Warranty
Products are warranted by Telex Communications, Inc. to be free from defects in materials and workmanship for a period of three years from the date of sale.

The sole obligation of Telex during the warranty period is to provide, without charge, parts and labor necessary to remedy covered defects appearing in products returned prepaid to Telex. This warranty does not cover any
defect, malfunction or failure caused beyond the control of Telex, including unreasonable or negligent operation, abuse, accident, failure to follow instructions in the manual, defective or improper associated equipment,
attempts at modification and repair not authorized by Telex, and shipping damage.

To obtain warranty service, follow the procedures entitled “Procedure for Returns” and “ Shipping to Manufacturer for Repair or Adjustment”.

This warranty is the sole and exclusive express warranty given with respect to RTS products. It is the responsibility of the user to determine before purchase that this product is suitable for the user’s intended purpose.

ANY AND ALL IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY ARE LIMITED TO THE DURATION OF THIS EXPRESS LIMITED WARRANTY.

NEITHER TELEX NOR THE DEALER WHO SELLS TELEX PRODUCTS IS LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND.

38110-238 Rev. A Copyright © 2003 Telex Communications, Inc. Printed in U.S.A.