Scribd
Upload
364 views1 page

Cold Start Injector Inspection: Engine Troubleshooting

The document provides instructions for inspecting a cold start injector on an engine by disconnecting the fuel inlet hose from the fuel filter outlet and using special tools to connect the injector to a fuel supply. The technician is instructed to turn the ignition on without starting the engine and connect terminals on the data link connector to cause the injector to spray fuel so its operation can be confirmed.

Uploaded by

Guadalupe Chambi Apaza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
364 views1 page

Cold Start Injector Inspection: Engine Troubleshooting

The document provides instructions for inspecting a cold start injector on an engine by disconnecting the fuel inlet hose from the fuel filter outlet and using special tools to connect the injector to a fuel supply. The technician is instructed to turn the ignition on without starting the engine and connect terminals on the data link connector to cause the injector to spray fuel so its operation can be confirmed.

Uploaded by

Guadalupe Chambi Apaza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

EG–181

ENGINE TROUBLESHOOTING – SFI SYSTEM

COLD START INJECTOR INSPECTION


EG0GN–01
1. INSPECT INJECTION OF COLD START INJECTOR
CAUTION: Keep injector clear of sparks during the test.
(a) Put a suitable container or shop towel under the fuel filter.
(b) Remove the union bolt and two gaskets, and disconnect the
fuel inlet hose from the fuel filter outlet.
HINT: Slowly loosen the union bolt.

(c) Install SST (two unions) to the injector and fuel filter outlet
with new gaskets and the union bolts.
SST 09268–41045(09268–41080,09405–09015)
(d) Connect SST (hose) to the unions.
SST 09268–41045
(e) Connect SST (wire) to the injector.
SST 09842–30055
(f) Put a container under the injector.
(g) Reconnect the battery negative (–) cable.
(h) Turn the ignition switch ON.
NOTICE: Do not start the engine.

(i) Using SST, connect terminals +B and FP of the data link


connector 1.
SST 09843–18020

(j) Connect the test probes of the SST (wire) to the battery, and
check that the fuel spray is as shown.
SST 09842–30055
NOTICE: Perform this check within the shortest possible
time.

Downloaded from [Link] manuals search engine

You might also like