Scribd
Upload
107 views2 pages

Q-It Is Required To Design A Piping System To Supply The Chilled Water For The Three Air Handling

The document provides information to design a piping system to supply chilled water to three air handling units (AHUs) located on different floors, including inlet/outlet water temperatures, heat capacities, pump efficiency, and pressure losses. It asks to: 1) Draw the piping system with all components, 2) Determine pipe diameters, velocities, and pressure losses for each section, and 3) Calculate the pump head pressure and power required.

Uploaded by

Mohsen Hassan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
107 views2 pages

Q-It Is Required To Design A Piping System To Supply The Chilled Water For The Three Air Handling

The document provides information to design a piping system to supply chilled water to three air handling units (AHUs) located on different floors, including inlet/outlet water temperatures, heat capacities, pump efficiency, and pressure losses. It asks to: 1) Draw the piping system with all components, 2) Determine pipe diameters, velocities, and pressure losses for each section, and 3) Calculate the pump head pressure and power required.

Uploaded by

Mohsen Hassan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Q-It is required to design a piping system to supply the chilled water for the three air handling

units. By using the attached information in figure (2), two pipe system, reverse return pipe,
inlet chilled water to AHU is (6 0C) and outlet chilled water from AHU is (12 0C) specific heat
(4.19 KJ/kg.k), efficiency of the water pump (70%), and water pressure losses in the chiller
(60kpa) and in the cooling coil (20kpa) to find the following:
1- Draw the complete system with all components such as valves, fittings, equipment and
all other necessary accessories.
2- The diameter of the pipe, water velocity and water pressure losses for each section in
the system.
3- Head pressure in H2O and power of pump.

2m 4m 16m

AHU-3 RSH=90 KW Second floor


RLH=17KW
OASH=20KW 4m
OALH=4KW

AHU-2 RSH=90 KW First floor


RLH=17KW
OASH=20KW 4m
OALH=4KW
Shaft

AHU-1 RSH=90 KW Ground floor


RLH=17KW
OASH=20KW 4m
OALH=4KW

Mechanical Room

Condenser
4m
Evaporator
Pump
Chiller

Figure (2)

You might also like