Scribd
Upload
147 views1 page

4:1 Multiplexer Logic Guide

This document provides instructions for building a 4:1 multiplexer circuit using logic gates on a kit. The circuit uses two AND gates and one OR gate to select one of four input signals (D0, D1, D2, D3) based on the values of the two selection bits (S0, S1). A truth table is provided showing the output (Y) for each combination of S0 and S1.

Uploaded by

Shraavani Tople
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
147 views1 page

4:1 Multiplexer Logic Guide

This document provides instructions for building a 4:1 multiplexer circuit using logic gates on a kit. The circuit uses two AND gates and one OR gate to select one of four input signals (D0, D1, D2, D3) based on the values of the two selection bits (S0, S1). A truth table is provided showing the output (Y) for each combination of S0 and S1.

Uploaded by

Shraavani Tople
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

9/23/22, 8:56 AM 4:1 Multiplexer

INSTRUCTIONS

Experiment to perform logic of 4:1 Multiplexer on kit

Power Switch

V : +5V
cc

7411 AND Gate 7411 AND Gate



4072B OR Gate

S0

GN

S1

D3=1
D0
LED OUTPUT

R2:330 ohm (Y)


GND

D1
R1:330 ohm
LED GND
R3:330 ohm
GND

D2
LED
R4:330 ohm
GND

D3
LED
R5:330 ohm
GND
      TRUTH TABLE                    PRINT                               Add

Serial No. S0 S1 OUTPUT (Y) OUTPUT VALUE


1 0 0 D0 1
2 1 0 D2 0
3 0 1 D1 0
4 1 1 D3 1

[Link] 1/1

You might also like