QUICK START GUIDE
ELEVATED, LATCHED
1
KICKSTAND LATCH
Secure the kickstand in the latch while elevated.
2
REMOVE THE u8 GO FROM CASE
(OPTIONAL)
1 3
1. Press the latch release bar.
2. Lift the Kymeta™ u8 GO out of the spring latch.
3. Push the u8 GO towards the handle and lift.
3
BOTTOM LATCH DETAIL
Keep the u8 GO angle low for removal.
The latch won’t release if elevated beyond 30º.
4
KICKSTAND, STOWED
Remove the kickstand when mounting the u8 GO
onto a vehicle.
5
SECURE THE KICKSTAND
2
1
3
1. Align the kickstand and the base arrows.
2. Latch the kickstand in the base hooks.
3. Secure the kickstand with the pin.
6
REMOVE YAKIMA MIGHTY MOUNT
1
7
INSTRUCTIONS
1. Loosen the thumb screw and remove the clamp.
2. Lift the lower clamp pad.
3. Loosen the socket head cap screw with the
provided Allen wrench.
4. Remove the lower clamp.
8
INSTALL YAKIMA MIGHTY MOUNT
9
INSTRUCTIONS
1. Align the lower clamp with the T-nut in the
aluminum extrusion.
2. Thread the fastener into the T-nut and position
the mighty mount on the rail per the vehicle’s
crossbar spacing.
3. Install the lower clamp pad.
4. Install the upper bail. For sizing guidelines, see
Sizing Process in the following cards. Refer to
the manufacturer’s instructions for additional
details.
10
SIZING PROCESS:
YAKIMA MIGHTY MOUNT
1. Install the pad on the smaller bail “A” and
press to secure.
11
SIZING PROCESS
CLA
MP
BAS
E TOP
BOTTOM
2. Attach the bail to the top slot on the clamp base.
12
SIZING PROCESS
DIRE
CTIO
N OF
TRA
VEL
3. Install the mount on the crossbar with the hex
bolt facing the direction of vehicle travel. Use the
short bolt with the bail “A” and the long bolt
with the bail “B.”
13
SIZING PROCESS
1/8” MINIMUM
(NOT TO SCALE)
4. The bolt must protrude 1/8 in. from the bail when
installed on the crossbar. If there is not enough
thread exposed, move the bail to the bottom slot
from step 2.
14
SIZING PROCESS
5. If the bottom slot doesn’t work, install the pad on
the bigger bail “B” and repeat steps 2 and 3.
Use the long hex bolt with the bail “B.”
15
SIZING PROCESS
6. Attach the knurled wheel to the hex bolt and
tighten until the wheel no longer turns. If the
mount slides on the crossbar, repeat sizing
process.
16
For Contact Kymeta customer support at
[email protected] or call Kymeta 1-855-525-6638 for urgent issues.
12277 134th Ct. NE, Redmond, WA 98052 | Phone: 425.896.3700 | www.kymetacorp.com
© 2021 Kymeta Corporation. All Rights Reserved. KYMETA, KYMETA CONNECT, MAKING MOBILE GLOBAL,
and CONNECTED BY KYMETA are trademarks of Kymeta Corporation, with registrations or pending applica-
tions in the U.S. and/or other countries. All other trademarks are the property of their respective owners.
Document number: 700-00119-000 rev A
