PRODUCT INFORMATION

Standard Grade

®
KOCETAL K300EW
Kocetal K300EW is a general injection molding grade with slightly improved toughness than K300.
Property Test Method Units Value
Physical
Melt Index ASTM D1238 g/10min 9.0
Specific Gravity ASTM D792 - 1.41
Shrinkage ASTM D955 % 2.0
Water Absorption 23℃, Equilibrium 60%RH ASTM D570 % 0.22
Thermal
Melting Point ASTM D1525 ℃ 166
Heat Deflection Temperature under Load ASTM D648
HDT/A 0.45 MPa ( 4.6 kg/cm2 ) ℃ 158
2
HDT/A 1.82 MPa ( 18.6 kg/cm ) ℃ 110
Vicat Softening Temperature ASTM D1525 ℃ 162
-5
Coeff. Of Linear Thermal Expansion ASTM D696 × 10 cm/cm·℃ 13
Flammability UL 94 HB
Mechanical
Tensile Strength 23℃ ASTM D638 MPa (kg/cm2) 62 (630)
Tensile Elongation 23℃ ASTM D638 % 70
Flexural Strength 23℃ ASTM D790 MPa (kg/cm2) 91 (930)
Flexural Modulus 23℃ ASTM D790 MPa (kg/cm2) 2,500 (25,500)
Notched Izod Impact Strength 23℃ ASTM D256 J/m (kg·cm/cm) 75 (7.6)
Rockwell Hardness M scale ASTM D785 - 80
Electrical
Surface Resistivity ASTM D257 × 1016 Ω 1
14
Volume Resistivity ASTM D257 × 10 Ω·cm 1
Dielectric Strength ASTM D149 kV/mm 19
Dielectric Constant ASTM D150 - 3.7
Dielectric Dissiparation FactorConstant 106 Hz ASTM D150 - 0.006

The information provided in this data sheet is based on our present state of knowledge and is estimated by
KOLON PLASTICS, Inc. This information should not be used as guaranteeing specification limits.
KOLON PLASTICS, Inc. make no warranty and liability in connection with any use of this information.

KOLON PLASTICS, Inc.