Scribd
Upload
18K views4 pages

Bosch m7.9.8 Kia

The document provides instructions for connecting to a Bosch M798 KIA ECU in three ways: directly using cable F32GN037C; for boot and configuration mode using the same cable; and for a metal positioning frame using adapter F34DM010. Connections involve specific pins, cables, and ensuring the Trasdata power LED is on for direct connection without a metal frame.

Uploaded by

farid salmani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
18K views4 pages

Bosch m7.9.8 Kia

The document provides instructions for connecting to a Bosch M798 KIA ECU in three ways: directly using cable F32GN037C; for boot and configuration mode using the same cable; and for a metal positioning frame using adapter F34DM010. Connections involve specific pins, cables, and ensuring the Trasdata power LED is on for direct connection without a metal frame.

Uploaded by

farid salmani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
  • ECU Overview: Provides an overview image and initial description of the Bosch M798 KIA ECU, highlighting the lay-by pin location.
  • Direct Connection Instructions: Describes the direct connection process to the ECU, specifying cable usage and power requirements, complemented by a color-coded wire guide.
  • Boot&CNF1 Connection: Details the connection process for the BOOT and CNF1 wires with a specified cable, supplemented by a wire color and function table.
  • Metal Positioning Frame Connection: Explains the metal positioning frame connection process, requirements for appropriate soldering, and adapter usage, with illustrative images.

BOSCH M798 KIA

plugin 167

The lay-by pin is placed in the lower part of the ECU.

https://ecu.design
BOSCH M798 KIA

DIRECT CONNECTION
In order to connect to the ECU use the cable F32GN037C.
Make sure that the POWER led (red) on Trasdata is ON.
Do not use this connection with the metal positioning frame kit, it will be the F34DM011 adapter
to power the ECU.

ECU CONNECTOR

https://ecu.design
BOSCH M798 KIA

BOOT&CNF1 CONNECTION

Connect the BLUE and GREY wires of the cable F32GN037C as described here below :

https://ecu.design
BOSCH M798 KIA

METAL POSITIONING FRAME CONNECTION


For the metal positioning frame connection is required the F34DM010 adapter.
The single blue wire supplied with the adapter F34DM010 must be soldered on the CNF1 pad and
connected on the adapter F34DM010 as shown in the following picture.

https://ecu.design

You might also like