MALAYSIAN MS 2728:2023
STANDARD
y
nl
O
Used motor vehicle – Classification –
Requirements for evaluation
i ew
ev
Pr
ICS: 43.020, 43.040
Descriptors: used motor vehicle, requirements, evaluation, star rating, classification
© Copyright 2023
DEPARTMENT OF STANDARDS MALAYSIA
DEVELOPMENT OF MALAYSIAN STANDARDS
The Department of Standards Malaysia is the national standards and accreditation body of Malaysia.
The main function of Department of Standards Malaysia is to foster and promote standards,
standardisation and accreditation as a means of advancing the national economy, promoting industrial
efficiency and development, benefiting the health and safety of the public, protecting consumers,
facilitating domestic and international trade and furthering international cooperation in relation to
standards and standardisation. The use of Malaysian Standards is voluntary except in so far as they
are made mandatory by regulatory authorities by means of regulations, local by-laws or any other similar
y
ways.
nl
Malaysian Standards are developed through consensus by committees which comprise balanced
representation of producers, users, consumers and others with relevant interests, as may be
appropriate to the subject at hand. The development of a standard as a Malaysian Standard is governed
O
by the Standards of Malaysia Act 1996 [Act 549]. Section 18A of the act stipulated that, all Malaysian
Standards are owned by the Government of Malaysia and no part of a Malaysian Standard can be
reproduced in any form without the written permission of the Director General.
ew
For further information on Malaysian Standards, please contact:
Department of Standards Malaysia
Level 4 - 7, Tower 2, Menara Cyber Axis
Jalan Impact, Cyber 6
i
63000 Cyberjaya
Selangor Darul Ehsan
ev
MALAYSIA
Tel: 60 3 8008 2900
Fax: 60 3 8008 2901
http://www.jsm.gov.my
Pr
E-mail: [email protected]
MS 2728:2023
Contents
Page
Committee representation .......................................................................................................... ii
Foreword .................................................................................................................................... iv
y
Introduction .................................................................................................................................v
nl
1 Scope ................................................................................................................................. 1
2 Normative references ........................................................................................................ 1
3 Terms and definitions ........................................................................................................ 1
O
4 Code of ethics requirements .............................................................................................. 2
5 Organisation and management ......................................................................................... 3
6 Facilities and equipment .................................................................................................... 4
7 Process requirements ........................................................................................................ 5
ew
Bibliography ............................................................................................................................. 44
Annexes
i
Page
ev
Annex A Information on used motor vehicle ........................................................................... 10
Annex B Compulsory/pre-requisite inspection (L, M1 and N1 category) ................................. 12
Annex C Above carriage evaluation (M1 and N1 category) .................................................... 13
Annex D Undercarriage evaluation (M1 and N1 category) ...................................................... 16
Pr
Annex E Interior evaluation (M1 and N1 category) .................................................................. 21
Annex F On-board diagnostic evaluation (M1 and N1 category) ............................................. 24
Annex G Body evaluation (L category) ................................................................................... 25
Annex H Engine evaluation (L category) ................................................................................ 27
Annex J Electrical evaluation (L category) ............................................................................. 29
Annex K On-board diagnostic evaluation (L category – above 150 cc) ................................. 31
Annex L Star rating ................................................................................................................ 32
Annex M Example of calculation for used motor vehicle evaluation (M1 and N1 category).... 33
Annex N Example of calculation for used motor vehicle evaluation (L category) .................. 36
Annex P Example of used motor vehicle evaluation report ................................................... 40
© DEPARTMENT OF STANDARDS MALAYSIA 2023 - All rights reserved i
MS 2728:2023
Committee representation
The National Standards Committee on Transport (NSC 12) under whose authority this Malaysian Standard was
developed, comprises representatives from the following organisations:
Agensi Pengangkutan Awam Darat
Department of Environment
Department of Standards Malaysia (Secretariat)
y
Jabatan Laut Malaysia
Jabatan Pengangkutan Jalan Malaysia
Malaysia Automotive Component Parts Manufacturers Association
nl
Malaysia Automotive, Robotics and IoT Institute
Malaysian Automotive Association
Malaysian Institute of Road Safety Research
Malaysian Investment Development Authority
Ministry of Domestic Trade and Cost of Living
Ministry of Investment, Trade and Industry
Ministry of Transport
Perusahaan Otomobil Nasional Sdn Bhd
Pertubuhan Keselamatan Sosial
Polis Diraja Malaysia
Puspakom Sdn Bhd
O
Motorcycle and Scooter Assemblers and Distributors Association of Malaysia
Perodua Manufacturing Sdn Bhd
ew
SIRIM QAS International Sdn Bhd
The Chartered Institute of Logistics and Transport
Universiti Putra Malaysia
Universiti Teknologi Malaysia
The Technical Committee on Safety and Impact Testing (NSC 12/ TC 1) which supervised the development of this
Malaysian Standard consists of representatives from the following organisations:
i
Angkatan Tentera Malaysia
Autoliv Hirotako Safety Sdn Bhd
ev
Department of Standards Malaysia (Secretariat)
Federation of Malaysian Manufacturers
Jabatan Pengangkutan Jalan Malaysia
Malaysia Automotive, Robotics and IoT Institute
Malaysian Automotive Association
Malaysian Institute of Road Safety Research
Ministry of Domestic Trade and Cost of Living
Pr
National Metrology Institute of Malaysia
Perodua Manufacturing Sdn Bhd
Perusahaan Otomobil Nasional Sdn Bhd
Polis Diraja Malaysia
Puspakom Sdn Bhd
QAV Technologies Sdn Bhd
SIRIM QAS International Sdn Bhd
Universiti Putra Malaysia
The Working Group on Vehicle Inspection (NSC 12/ TC 1/ WG 9) which developed this Malaysian Standard consists
of representatives from the following organisations:
Automotive Accessories Traders Association of Malaysia
AucNation Synergy Sdn Bhd
Department of Environment
Department of Standards Malaysia (Secretariat)
EZAuto Inspection Sdn Bhd
Jabatan Pengangkutan Jalan Malaysia
Malaysia Automotive, Robotics and IoT Institute
ii © DEPARTMENT OF STANDARDS MALAYSIA 2023 - All rights reserved
MS 2728:2023
Committee representation (continued)
Malaysian Automotive Association
Malaysian Institute of Road Safety Research
Ministry of Domestic Trade and Cost of Living
Ministry of Local Government Development
Motorcycle and Scooter Assemblers and Distributors Association of Malaysia
Perodua Sales Sdn Bhd
y
Port Klang Authority
Proton Edar Sdn Bhd
Puspakom Sdn Bhd
nl
Royal Malaysian Customs Department
Co-opted member:
Carsome Sdn Bhd
O
i ew
ev
Pr
© DEPARTMENT OF STANDARDS MALAYSIA 2023 - All rights reserved iii
MS 2728:2023
Foreword
This Malaysian Standard was developed by the Working Group on Vehicle Inspection
(NSC 12/TC 1/WG 9) which was supervised by the Technical Committee on Safety and Impact
Testing (NSC 12/TC 1) under the authority of the National Standards Committee on Transport
(NSC 12).
y
Compliance with a Malaysian Standard does not of itself confer immunity from legal obligations.
nl
O
i ew
ev
Pr
iv © DEPARTMENT OF STANDARDS MALAYSIA 2023 - All rights reserved
