V1007 MATERIAL SUMMARY
90 Durometer, Black, Commercial Grade FKM
REQUEST
Request A
a QUOTE
Quote
FKM compounds are widely used in chemical, automotive, aerospace and industrial
applications. These compounds offer excellent chemical and temperature resistance. Marco
Rubber stocks all USA standard Viton O-Rings sizes, thousands of metric Viton O-Ring and
non-standard sizes.
ABOUT #V1007 FEATURES
V1007 is a 90A durometer, commercial • High temperature resistance.
grade compound. It is an FKM Type A. • High Durometer.
There are many additional specialty • Excellent resistance to acids, fuels,
compounds based on A, B, F, GLT, GFLT, mineral oils, greases, aliphatic, aromatic
LTFE and ETP polymer types. Please and chlorinated hydrocarbons, non-
contact
[email protected] for flammable hydraulic fluids (HFD) and many
assistance in selecting a specialized organic solvents and chemicals.
compound when increased resistance to • Excellent resistance to aging and ozone.
temperature, chemicals, or physical • Low gas permeability, low compression
properties is required. set
APPLICATION EXAMPLES ADDITIONAL INFORMATION
• Vacuum applications • Service Temperature of -15° to 437°F
• Acidic applications • Cure System: Bisphenol
• Petroleum applications • Spec: ASTM D2000 M2HK910 A1-10 B38
EF31 EO78
This information is accurate and reliable to the best of our knowledge. However, Marco Rubber makes no
warranty, expressed or implied, that parts manufactured from this material will perform satisfactorily in the
customer’s application. It is the customer’s responsibility to evaluate parts prior to use.
READY TO SEAL THE SUCCESS OF YOUR APPLICATION?
800-775-6525 • marcorubber.com Revision 1, 04-2021
V1007 MATERIAL SUMMARY
90 Durometer, Black, Commercial Grade FKM
REQUEST
Request A
a QUOTE
Quote
PHYSICAL PROPERTIES
ORIGINAL PROPERTIES ASTM D2000 Requirements Typical Test Results
Hardness, Shore A 90 +/- 5 90
Color Black Black
Tensile Strength, psi 1,450 min. 1843
Ultimate Elongation, % 100 Min. 128
Specific Gravity ----- 1.833
HEAT RESISTANCE – A1-11, ASTM D 573 (70 hrs. @ 250°C) ASTM D2000 Requirements Typical Test Results
Hardness Change, points +10 (max) +2
Tensile Strength Change, % -25 (max) -3.1
Ultimate Elongation Change, % -25 (max) -9.5
COMPRESSION SET – B38, ASTM D 395 Method B (22 hrs. @ 200°C) ASTM D2000 Requirements Typical Test Results
Permanent Set % 50 (max) 20.7
FLUID RESISTANCE – ASTM Fuel C – EF31, ASTM D471(70 hrs. @ 23°C) ASTM D2000 Requirements Typical Test Results
Hardness Change, points +/- 5 -3
Tensile Strength Change, % -25 (max) -13.2
Ultimate Elongation Change, % -20 (max) -6.7
Volume Change, % 0 to + 10 2.2
FLUID RESISTANCE – ASTM #101 Oil – EO78, ASTM D471(70 hrs. @
ASTM D2000 Requirements Typical Test Results
200°C)
Hardness Change, points -15 to +5 -9
Tensile Strength Change, % -40 (max) -15.8
Ultimate Elongation Change, % -20 (max) -8.2
Volume Change, % 0 to + 10 11.1
