LED – FLEXIBLE COB STRIP
LED – FLEXIBLE COB STRIP IP20
LED TYPE:COB-RGB (630 chips) CRI>90
1. Electrical Parameters
Input voltage DC 24V
IP Grade IP20
Standard Meter 5 MTS
Wide 10mm
Working temperature -20 ~+60°C
Storage temperature -40 ~+60°C
Humidity 40-70% RH
Warranty 3 years
Certification CE
Viewing Angle 180°
CRI RGB
KGP Electronics GmbH KGP-V0.01
Hueckstraße 19
DE-58511 Lüdenscheid
LED – FLEXIBLE COB STRIP
2. Features and benefits:
● Dimmable 24V constant voltage strip ( SELV)
● Small colour tolerance (MacAdam 3 )
● Self-adhesive 3M tape at the backside for simple mounting on different surfaces
● High design freedom due to individual cut-options
● Colour temperature RGB
● System solution in combination with KGP constant voltage LED Driver (fixed output and
dimmable)
● 630 COB chips
KGP Electronics GmbH KGP-V0.01
Hueckstraße 19
DE-58511 Lüdenscheid
LED – FLEXIBLE COB STRIP
3. Optical Parameters
630 chips
color Luminous flux
Model No. temperature Chips Divisibility Power
(1 meters)
FS18024RGBR520COB630 RGB 703lm/m 630 33,33mm 18W/m
red 171lm/m
blue 102lm/m
green 430lm/m
4. Packing:
180mm
Label
Label
390mm
80mm
50mm
160mm
Note:5 meters/reel, 1reel/antistatic bag, 3 antistatic bags/box, 20 box/export carton；
KGP Electronics GmbH KGP-V0.01
Hueckstraße 19
DE-58511 Lüdenscheid
LED – FLEXIBLE COB STRIP
5. Drawing ( Unit: mm):
630 chips/m
24V
Wide 10mm
Divisibillity 33,33mm
6. Instructions:
● Please use this product with 24V DC. The LED strip does not have protection against short circuit
overload or overheating. Therefore it is absolutely necessary to operate the strips with an
electronically stable power supply offering protection against the above mentioned safety risks.
● There is 3M double side adhesive tape on the backside for easy installation. Care must be taken to
provide a clean and dry surface. The mounting substrate must have sufficient structural integrity.
Take care to completely remove the protective backing.
Once the strip is appropriately positioned, press on the strip to fasten it.The wire with gray line is anode,
whiles the white is cathode. Wrong polarity will lead to no light emission only; the strip will not be
destroyed. What only needs to is to correct polarity.
● Cut off the bared wires if there is any, and use electrical insulation tape or wiring end cap to
insulate the end of the wires to prevent short circuits.
● Installation of LED strips (with power supplies) should be made with regard to all applicable
electrical and safety standards. Only qualified personnel should be allowed to perform installations.
KGP Electronics GmbH KGP-V0.01
Hueckstraße 19
DE-58511 Lüdenscheid
