Beaded Chain Barefoot Sandals
A Crochet Pattern by Farrah Hodgson
BEADED CHAIN BAREFOOT SANDALS
Take your crochet barefoot sandals to the
Materials: next level!
Aunt Lydia’s Size 20 Fine Crochet
Thread; 100% Mercerized Cotton, 400 Experience using an extra small hook and
yds per skein. (Small amount needed
super fine thread is a bonus (time to get out
for this project, approx. 25yds); White
those reading glasses!) but not limited…
Beginning in the center, you will work five
small rings, continued on in rounds. From
there, you will begin to work the beaded
Size 0.75mm steel crochet hook
170 small glass E-beads; 6/0, (hook
chains in different lengths, which connect to
must be able to pass through center of the same point on each side. The straps finish
beads) these sandals off, using a lobster jewelry clasp
Two lobster clasps (or desired clasp) for closing.
Tapestry Needle
Photo Tutorial Included!
Size: Adult
Gauge: Over pattern; length of center of
sandal without beads and toe = approx. 3.5
inches
Measurements: Length= approx. 4 inches;
length of straps= 9.5 inches (custom available)
Stitches Used:
Ch= Chain
Sl st= Slip Stitch
Sc= Single Crochet
Special Term Used:
Bead= Slip Stitch a bead (insert hook
into center of bead, yarn over, pull a
loop through bead; slip same loop
through first loop on hook.
© Firene Designs 2014-2015. All Rights Reserved.
No part of Firene Designs patterns may be
reproduced, copied, modified or adapted, without
the prior written consent of the author, unless
otherwise indicated.
Commercial use and distribution of the contents of
the pattern is not allowed without express and
prior written consent of the author.
PATTERN
Ch 40
Rnd 1: Sl st in 2nd ch from hook; (ch 5- skip next 5 chs, sl
st in next 3 chs) 4 times; ch 5- skip next 5 chs, sl st in last
ch.
Rnd 2: Ch 1, do NOT turn; -working down opposite side
of beginning chain- (work 11 sc in next ch 5 space, sl st
in next 3 chs) 4 times, work 11 sc in last ch 5 space, skip
over last sl st;
-working up side of Rnd 1- (work 11 sc in next ch 5
space, sl st in next 3 sl sts) 4 times, work 11 sc in last ch
5 space, sl st in 1st sc to join.
Rnd 4 (Beads and Chains): Ch 20, (bead, ch 1) 7 times…
Rnd 3: Ch 1, do NOT turn; (sc in next 11 sc, ch 1- skip
over next 3 sl sts) 4 times, sc in next 11 sc; ch 28 (toe
loop); … skip next 5 sc, sl st in next 6 sc; skip over center ch, sl
st in next 6 sc…
-opposite side- (sc in next 11 sc, work a sc over **entire
center) 4 times, sc in last 11 sc, sl st in 1st sc to join.
**See Photo
… ch 1, (bead, ch 1) 12 times…
… sl st back in the 20th chain of beginning ch 20 to join…
… sl st back in same 20th ch of very beginning ch 20 to
join…
… ch 1, (bead, ch 1) 17 times; skip next 5 sc- skip over
center ch- skip next 5 sc, sl st in next 6 sc, skip over
center ch, sl st in next 6 sc…
… ch 1, (bead, ch 1) 27 times…
… ch 1, (bead, ch 1) 22 times…
… skip next 5 sc, -skip over center ch, - skip next 5 sc, sl
st in next 6 sc…
… sl st in next 28 sts (toe), sl st in next 6 sc…
… ch 1 (this is the CONNECTING CHAIN), ch 1; (bead, ch
1) 22 times…
… ch 1, (bead, ch 1) 27 times…
… skip next 5 sc, -skip over center sc, -skip next 5 sc, sl st … ch1, (bead, ch 1) 12 times…
in next 6 sc, skip over center sc, sl st in next 6 sc…
… skip next 5 sc, -skip over center sc, -skip next 5 sc, sl st
in next 6 sc, skip over center sc, sl st in next 6 sc…
… ch1, (bead, ch 1) 17 times, work a sl st in the
connecting ch…
… ch 1, (bead, ch 1) 7 times, sl st in the connecting ch…
… ch 20, skip last 5 sc, sl st in beginning ch to join. Do
NOT fasten off.
Left: Sc in next 20 chs to the left; ch 28, work a sl st
through the clasp attachment ring, turn; sc in next 28
chs, turn – facing back of sandal; sl st in next 20 sts.
Fasten off.
STRAPS (add or omit stitches from *ch 28* for a
custom fit)
Right: Ch1, turn; sc in each of the last 20 chs, ch 28,
work a sl st through the ring of the lobster clasp, turn;
sc in next 28 chs; turn facing front of sandal- sl st in the
next 20 sts. Do NOT fasten off.
Sew in ends. Make another one!
