ENGINE
EG028-07
Title:
ENGINE OIL LEAK
Technical Service Models:
BULLETIN ’07 Tundra (5.7 L, TMMI)
May 31, 2007
Introduction Some 2007 model year Tundra vehicles with a 5.7-liter engine may exhibit an oil leak
from the oil pan area. This concern may be caused by a leaking O-ring on the dipstick
tube. Use the following repair procedure to address the customer’s concern.
Applicable S 2007 model year Tundra (TMMI) vehicles equipped with a 5.7-liter engine and
Vehicles produced BEFORE the Production Change Effective VINs shown below.
Production MODEL PLANT DRIVETRAIN PRODUCTION CHANGE EFFECTIVE VIN
Change
Information 2WD 5TBEV541#7S454202
Tundra TMMI
4WD 5TBDV541#7S458366
NOTE:
The plant code is the 11th digit (S = TMMI, X = TMMTX).
Parts PREVIOUS PART NUMBER CURRENT PART NUMBER PART NAME QTY
Information
96721–19010 Same O–ring 1
Required TOOLS & MATERIAL QUANTITY
Tools &
ILSAC GF–4 Multi–grade SAE 5W–20 or 0W–20 As Needed
Material
Warranty OP CODE DESCRIPTION TIME OFP T1 T2
Information
111411 R & R Dipstick Tube O-ring 0.1 96721–19010 65 99
Applicable Warranty*:
This repair is covered under the Toyota Powertrain Warranty. This warranty is in
effect for 60 months or 60,000 miles, whichever occurs first, from the vehicle’s
in-service date.
* Warranty application is limited to correction of a problem based upon a customer’s specific complaint.
Toyota Supports ASE Certification Page 1 of 2
ENGINE OIL LEAK – EG028-07 May 31, 2007
Repair 1. Inspect leak location.
Procedure
2. If the leak is found to be coming from
the dipstick tube, remove the engine
oil dipstick tube.
3. Remove the old O–ring from the Pull
dipstick tube.
O–Ring
4. Apply a light coat of engine oil to the
NEW O–ring.
5. Install the NEW O–ring to the
dipstick tube.
6. Install the dipstick tube into the pan
with the bolt.
Torque: 10 NSm (102 kgfScm, 7 ftSlbs )
Push
7. Start the engine and verify the O–Ring
condition is repaired.
Page 2 of 2
