www.andhrajyothy com .

ÚflO˝ßÊ˛-Δ>-ªÍßä˛ ∑ Vʸ$ΔÊˇ$–ÈΔÊˇÖ 28 Ø˲–ö˛Ö∫Δäˇ 2019 Á‹tyÓ˛ 15

NPDCL JLM MODEL PAPER

1. If Four 10 � F capacitors are connected 20. The time constant of a series R- L circuit (C ) 1600 Watts (D) 6400 Watts 52. The controlling torque in gravity con-
in parallel the net capacitance is is given by 38. In short circuit test on a transformer we trolled meter is proportional to
(A) 2.5 � F (B) 40 � F (A) L2 R (B) LR (C ) LR (D) L/R generally short circuit (A) Cos (B) Sin (C) Tan (d ) Cot
(C) 20 � F (D ) 15 � F 21. For an RLc series circuit current at (A) Low Voltage winding 53. Which one of the following does not
2. Three resistance of R ohms each are con- series resonance is (B) High Voltage Winding employ a null method of measurement.
nected in delta It's equivalent resistances (A) Maximum at leading PF (C) Either low or high voltage winding (A) DC potential meter
in star connection per phase is (B) Maximum at Lagging PF (D) Neither Low nor high Voltage winding (B) Kelvin double bridge
(A) R/3 each (B) R each (C) Maximum at unity PF 39. The iron loss in a 100 KVA transformer (C) AC potentio meter (D) Meggar
(C) 3 R each (D ) 3 R, R & R/3 (D) Minimum at unity PF is 1 KW and full load copper losses are 54. PMMC instrument normally use
3. An Ideal current source has zero 22. In a series R-L-C circuit the Q-Factor is are 2 KW. The maximum efficiency (A) No damping is required
(A) Internal conductance given by occurs at a load of (B) Fluid friction damping
(B) Internal resistance (A) Q =1/R (B)Q=F/W (C ) 1/R (D) Q=R (A) 70.7 KVA (B) 141.4 KVA (C) Eddy current damping
(C ) Voltage on No Load (D) Ripple 23. The power Factor of an a.c. circuit is (C) 50 KVA (D) 100 KVA (D) Air friction damping.
4. Three Inductors each OF 60 MH are given by 40. In a transformer zero voltage regulation 55. Two holes as a drilled in the disc on a
connected in delta. The value of (A) XL/R (B) Z/R (C ) R/XL (D) R/Z at Full load is diameter of energy meter.
Inductance of each arm of the equivalent 24. The active and reactive powers of an (A) Not possible (A) Increase ventilation
star connection is inductive circuit are 60 w and 80 VAR (B) Possible at unity power Factor Load (B) Reduce weight of disc
(A) 10 mH (B) 15 mH respectively. The power Factor of the (C) Possible at Leading Power Factor Load (C) Eliminate cripping on no loaded
(C ) 20 mH (D) mH circuit. (D) Possible at Lagging Power Factor Load (D) Increased deflection torque
5. The break down voltage of silicon diode is (A) 0.5 Log (B) 0.6 Log 41. In a three phase delta transformer one 56. Accurate measurement of very low
(A) 0.2 volts (B) 0.6 volts (C ) 0.75 Log (D) 0.8 Lag phase burns up the transformer will resistance is possible with
(C ) 0.3 volts (D) 0.2 volts 25. The Knee Voltage of Germanium diode is supply. (A) Mugger (B) Wheat Stone bridge
6. The impedance of the circuit is (4 + J3) (A) 1.0 v (B) 0.3 V (C) 0.7 mv (D) 0.3 V (A) 57, 7% or its rating (B) Zero out put (C) Kelvins double bridge
ohms. The power Factor of the circuit is 26. Which of the following materials is a (C) 63% of its out put rating. (D) Wagner's earthing bridge
(A) 0.6 Lead (B) 0.8 Lead semiconductor (D) at Full out put rating. 57. Die Electric losses in a capacitors is bet
(C) 0.6 Log (D) 0.8 Lag (A) Selenium (B) Bismath 42. A transformer has negative voltage regu- measured by
7. Three resistors each of R are connected (C) Silica (D) Chromium lation . When its load power Factor is (A) Weigh bridge (B) Scheming bridge
in star what is the value of equivalent 27. The Ebers moll model is applicable to (A) Zero (B) Unity (C) Loading (D) Lagging (C) Anderson bridge (D) Hay's bridge
delta connected resistors. (A) BJT (B) NMOS transistor 43. The Router impudence of a slip ring 58. The unit of luminous flux is
(A) R/2 (B) 2 R (C ) R/3 (D ) 3 R (C) UJT (D) JFET induction motor is 100.1+j0.6) the resist- (A) Webbers (B) Lax
8. The condition of electroplate in a battery 28. The input resistance of a FET is of the ance 1ph to be instested intorotoo to get (C ) Lumens (D ) Candela
is measured in terms of order of maximum torque at starting should be 59. If 'd is the distance of a surface from a
(A) Current value (B) Specific Gravity (A) 100 (B) 10 K (C) 1M (D) 100 M (A) 01. (B) 0.3 (C) 0.4 (D ) 0.5 source the illumination upon the surface
(C) Acid contents (D) Voltage output 29. Ideal operational amplifier has 44. The crawling in an induction motor is will vary as
9. The colour of negative plate of a led acid (A) Infinite Input resistance caused by (A) D (B) D2 (C) 1/d (D) 1/d 2
battery is (B) Infinite output resistance (A) High loads (B) Low supply voltage 60. The solution of point by point method
(A) Brown (B) Grey (C ) White (D) Black (C) Small gain (D) Small bandwidth (C) Improper design of malchine adopted to solve the swing equation
10. The normal voltage of a fully charged led 30. The series motors have a relatively (D) Halmonic developed bymitor (A) Power angle
acid cell is (A) Zero starting torque 45. Universal motor isa - motor (B) Critical cleansing angle
(A) 1.1 V (B) 1.5 V (C ) 2.2 V (D) 3.0 V (B) High Starting Torque (A) Single phase induction motor (C) Clearing angle (D) Clearing time
11. A 12 V Led acid battery consists of (C) Low starting Torque (B) Synchronous (C) Shunt (D) Series 61. Which of the following heat exchanges is
(A) Three cell in series (D) Medium starting Torque 46. When the rotor of a three phase induc- used to raise the temperature of steam
(B) Six cell in series 31. In a dc shunt motor the torque developed tion motor blocked the slip is from normal to sopes saturation level.
(C) Three cells in parallel is 15 N-m at 10 A of Load current. If the (A) 0 (B) 0.1 (C) 0.5 (D) 1 (A) Air pre heater (B) Economised
(D) Six cells in parallel load current is doubled then new torque 47. Which of the following motor will give (C ) Super Heats (D) Condenser
12. The capacity of the battery is expressed in will be relatively high starting torque. 62. ACSR stands for
(A) Watt - Hour (B) Ampere/sec (A) O-N-m (B) 15N-m (A) Capacitor Start motor (A) Aluminium copper steel reinforced
(C ) Amepere-hour (D) Kilo watt (C) 30 N-m (D) 60 N-m (B) Capacitor Run motor (B) Aluminium copper standard reinforced
13. The unit of reluctance is 32. The current in armature conductors of a (C) Split Phase motor (C) Aluminium conductor still reinforced.
(A) Ampere/cm2 (B) Weber/m2 dc machine is (D) Shaded pole motor (D) Aluminium conductor standard
(C) Ampere turns/weber (A) Pure dc (B) Pulstating dc 48. If a induction motor with certain ratio of reinforced.
(D) Ampere/weber (C ) ac (C) Pure dc pulsating dc rotor to stator slats runs at the 1/78th of 63. The bundling of conductor is done pri-
14. Tesla is the SI unit 33. The commutator in a d.c machines acts as the normal rated speed the motor is said marily to
(A) Flux density (A) A mechanical inverter to be (A) Reduce resistance
(B) M agneto motive force (B) A mechanical rectifier (A) Jogging (B) Crawling (B) Increases resistance
(C) Reluctance (D) magnetic field strength (C) Current controller (D) either (a) or (b) (C) Cogging (D) Hunting (C) Increases radio interference
15. What is the similar magnetic term for 34. Wave winding is employed in a dc 49. Toreverse phase sequence of voltage gen- (D ) Reduce radio interference
the electrical term of conductance machine for erated in the alternates should be
(A) Reluctance (B) Flux density (A) High current and Low Voltage rating (A) Not possible to change the phase (—$VʸôÈ {Á≥‘Ë˝≤À$, Á‹–ö˛*´ßëØÈÀ$ ΔÛˇÁ≥sÏ˝ Á‹tyÓ˛ÃZ)
(C) Permence (D) Field intensity (B) Low current and high voltage rating sequence
16. The Formula of dymamically induced (C) High current and high voltage rating (B) Interchange any two of its phase CH.ASHOK BABU
EMF is (D) Low current and Low voltage rating terminals EASY TEACH Academy
(A) BLV Volts (B) BLV Sin O Volts 35. The Eb/v ratio of a DC motor is an indi- (C) Interchange all three of its field winding
(C) BLV COS O Volts (D) BL Sin O Volts cation of its (Eb is the back emF and V is (D) Reverse the connection of its field Answers
17. An Electromagnet of length 10 cm with the applied voltage across the Armature winding. 1) B 14) D 27) A 40) C 53) D
magnetizing force of 1500 AT/mt works (A) Speed regulation (B) Starting torque 50. The damping winding in a synchronous 2) A 15) C 28) D 41) A 54) C
in magnetizing circuits calculates its (C) Efficiency (D) Running torque motor is generally used. 3) A 16) B 29) A 42) C 55) C
magneto motive force (MMF). 36. A transformer can have regulation closer (A) To prevent hunting & provide the start- 4) C 17) C 30) C 43) D 56) D
(A) 15000 A.T (B) 1500 A.T to zero ing torque (B) Toreduce noise level 5) B 18) C 31) C 44) D 57) B
(C ) 150 A.T (D ) 15 A.T (A) On lagging power factor (C) To reduce eddy circuit 6) C 19) A 32) C 45) D 58) C
18. Which one is the paramagnetic material (B) On leading power factor (D) To provide starting torque only 7) D 20) B 33) D 46) D 59) D
(A) Bismuth (B) Wood (C) Air (D) Glass (C) On zero power factor 51. The voltage regulation of an alternator 8) B 21) C 34) B 47) A 60) B
19. The relation between the resonant fre- (D) On unity power factor depends on 9) B 22) B 35) C 48) B 61) C
quency FO and the half - power frequen- 37. The full load copper Loss of a trans- (A) Nol load current only 10) C 23) D 36) B 49) B 62) A
cies F1 and F2 is former is 1600 watts at half load the cop- (B) Power factor only 11) B 24) B 37) A 50) C 63) B
(A) FO = f1 F2 (B) FO = F1 + F2/2 per loss will be (C) Both load current and power factor 12) C 25) B 38) A 51) C
(C ) FO = F1 F2 (D) FO2 = F1 + F2 (A) 400 Watts (B) 80 Watt (D) Load current only 13) C 26) C 39) A 52) B