SOUND PACK CONFIGURATOR BMW Z4 Roadster (E89) 2009 - 2016 Base sound system
Sound Pack Configurator
OEM sound system upgrade for:
BMW // Z4 7
Roadster (E89) // 2009 - 2016
Upgrade Level
BASE SOUND SYSTEM
Important notices
1) In case of a configuration including the 2-way kits, please note that it is compatible only with cars that have the OEM placement for the front
tweeters as standard. Otherwise, the OEM placement for tweeters must be purchased from an authorized BMW® dealer in order to install the Audison
Prima BMW tweeters of the K4E and K4M 2-way kits. 2) The amplifier leads to an excessive amplification for the service signals (parking sensors, door
opening, turn signals etc…). It is suggested to check the settings menu of the OEM head unit and to set their volume level at the minimum possible.
If the attenuation is still insufficient, please contact the vehicle dealer. 3) In case of vehicles equipped with an ASD system the amplification of the engine
sound is excessive. Depending on the vehicle model, the user can add an AP H ASD BYPASS harness to bypass that system, or disable that function
with dedicated softwares. If these options are not available, please contact the vehicle dealer.
AMP + FRONT
AP8.9 bit + Small basket 2way front + cables
Components
Phone: +39 0733 870800 / General inquiries: [email protected] Page 1/5
SOUND PACK CONFIGURATOR BMW Z4 Roadster (E89) 2009 - 2016 Base sound system
AP8.9 bit
Quantity: 1
Position: Trunk
Description: The AP8.9 bit amplifier was designed by Audison R&D Department to
achieve maximum sound quality in OEM Integration applications. The powerful
management software proves the ability to acquire the bit Drive presets which the
Audison team fine-tuned specifically for your car. Thanks to the innovative power
supply stage, a power of 520 W total can be achieved in an extremely compact case.
The non-amplifiable ninth channel can be used to drive a subwoofer via the mono
AP1 D amplifier.
AP T-H BMW01
PRIMA T-HARNESS BMW
Quantity: 1
Position: Dashboard
Description: T-Harness “DCC” is the Plug&Play solution for BMW to integrate
Audison Prima with the factory car audio system. The battery positive is taken from
the head unit without the need of reaching the engine compartment thanks to the
DCC* solution. *The DCC solution, (Direct Cockpit Current) can be used combined
with the AP bit amplifiers’ feature which controls the amplifier absorption peaks,
protecting the car power supply system.
Phone: +39 0733 870800 / General inquiries: [email protected] Page 2/5
SOUND PACK CONFIGURATOR BMW Z4 Roadster (E89) 2009 - 2016 Base sound system
AP 560P&P I/O
ISO EXTENTION IN/OUT 560 cm / 220 in
Quantity: 1
Position: Cabin
Description: Prima Extension cable with Plug&Play connections allows total
freedom in positioning the AP bit amplifiers. Two extension typologies are available:
input only, to only send the audio signal coming from the head unit to the AP bit
amplifiers, or input/output, transmit also the AP bit amplifiers’ output signal to the
factory audio system. To do so, the AP Extension Cables IN/OUT needs to be
installed together with the AP Speakers Output Cables (see following paragraph). By
use of the input/output extension, the installer is free to choose which configuration
to adopt. Actually, thanks to the AP Extension cables, each single channel of the AP
bit amplifier is sent to any of the speakers in the car, so the installer is free to carry
out the desired configuration. For example: standard front (2ch TW+WF),
multi-amplified front (2ch TW + 2ch WF), multi-amplified front with 4 bridged
channels (130W @ 4ohm) for the woofers (2ch TW + 4ch bridge WF) and all the
other possible combinations.
AP SPK OUT 8.9
8CH OUTS CIRC. TERMINALS FEMALE
Quantity: 1
Position: Trunk
Description: AP SPK OUT 8.9 cable are dedicated to the connection of the AP8.9
bit amplifier with the input/output Extension cable. The Plug&Play connectors with
circle terminals are numbered (“CH1 +”, CH1 -“, etc…) for a foolproof connection.
There is no need to solder any cable.
Phone: +39 0733 870800 / General inquiries: [email protected] Page 3/5
SOUND PACK CONFIGURATOR BMW Z4 Roadster (E89) 2009 - 2016 Base sound system
APBMW BIAMP 1
BMW - MINI OEM replacement
Quantity: 1
Position: Cabin
Description: This Plug & Play harness provides the ability to bi-amplify the front
speakers of BMW and MINI vehicles that are not provided with an OEM amplifier.
The APBMW BIAMP 1 is installed under the vehicle seat and is connected to the
subwoofers. The “T” connection type allows the user to separately route the signal to
the front Mid-Hi housed in the car door and to the underseat sub, without the need to
cut the OEM cables. The cable is 450 cm long to reach the vehicle boot, where the
Audison bit amplifier is installed. The package contains a pair of cables, one for the
left channel and one for the right channel.
Phone: +39 0733 870800 / General inquiries: [email protected] Page 4/5
SOUND PACK CONFIGURATOR BMW Z4 Roadster (E89) 2009 - 2016 Base sound system
APBMW K4M
2-way system for BMW-MINI
Quantity: 1
Position: Front door
Description:
Audison has engineered this BMW upgrade component set with 100mm midranges,
29m Tetelon textile-dome tweeters, and matching crossover filters. The midrange
and coaxials are available in both 3-post frame sizes used by BMW and MINI.
Connection is plug-and-play. These speakers can be used as replacements with
OEM amplification, but the best results are attained when used in a system upgrade
that includes Audison Forza bit amplifiers and Prima BMW integration harnesses.
Tweeter: The Audison BMW tweeter has the largest dome of any BMW replacement
tweeter – while still snapping into the same mount as the OEM tweeter. The Audison
29mm dome has 34% more surface area than a 25mm dome, and that means more
output, a lower resonant frequency, and greater low-frequency extension. Most BMW
replacement tweeters have 25mm domes – only Audison offers this improved
performance. Audison R&D used a Tetolon silk/Cotton blend for light weight and
improved damping. The tweeter uses an inline crossover filter in plug-and-play
upgrade applications, and can also be used in fully-active configurations. An adapter
is included to fit this tweeter into certain rear-deck fitments, where the stock tweeter
is angled forward.
Midrange: This 100mm-class midrange uses a cast-aluminum frame, and is
designed for BMW and MINI fitments. Connection is plug-and-play. The
neodymium-alloy magnet provides more motor strength in a smaller package,
permitting fitment into the shallowest BMW doors. The vented rear pole assists with
cooling and improves power handling. For some models, an optional door mounting
adapter is available.
Phone: +39 0733 870800 / General inquiries: [email protected] Page 5/5
Powered by TCPDF (www.tcpdf.org)
