Scribd
Upload
341 views1 page

LJ2420B

Formolene® LJ2420B is a butene-based linear low-density polyethylene resin suitable for masterbatch formulations and compliant with FDA regulations for food contact. It has specific properties such as a density of 0.924 g/cc, a melt index of 20.0 g/10 min, and notable tensile strength and elongation values. The document outlines its applications, properties, and testing methods, emphasizing that actual properties may vary based on conditions.

Uploaded by

calidadluisg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
341 views1 page

LJ2420B

Formolene® LJ2420B is a butene-based linear low-density polyethylene resin suitable for masterbatch formulations and compliant with FDA regulations for food contact. It has specific properties such as a density of 0.924 g/cc, a melt index of 20.0 g/10 min, and notable tensile strength and elongation values. The document outlines its applications, properties, and testing methods, emphasizing that actual properties may vary based on conditions.

Uploaded by

calidadluisg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Formolene® LJ2420B

Linear Low Density Polyethylene (LLDPE) Resin for Compounding


Formolene® LJ2420B is a butene based compounding grade that is an excellent carrier resin for masterbatch
formulations.
Formolene® LJ2420B meets all requirements of the U.S. Food and Drug Administration as specified in 21
CFR 177.1520, covering safe use of polyolefin articles intended for direct food contact.

Suggested Applications:
Carrier resin for master batches

Additives:
Antioxidant - Yes
Nominal Values
ASTM
TEST ENGLISH SI
PROPERTY* METHOD Unit Value Unit Value
Density D1505 g/cc 0.924 g/cc 0.924
Melt Index, (190C/2.16) D1238 g/10 min. 20.0 g/10 min. 20.0
Molded Properties
Tensile Strength
Yield D638 psi. 2200 MPa 16
Break psi. 1300 MPa 9.2
Tensile Elongation
Break D638 % 60 % 60
Flexural Modulus – 1% Secant D790 psi. 60000 MPa 410
Durometer Hardness (Shore D, 15 sec) D2240 47 47
Notched Izod Impact D256A Ft-lb/in. 29 J/m 29
Note: All properties were derived from compression molded specimens. Actual properties may vary depending on operating conditions and additive
packages. Properties are not intended to be used as specifications.

Published 11/1/2019

6/19

You might also like