Scribd
Upload
75 views1 page

35MM FDSL

The In House Test Report evaluates a solid flush door by M/s. PLYWOOD CORPORATION for the NIFT project, confirming it meets IS:2202 (Part-1)/1999 standards. All tested parameters, including dimensions, squareness, flatness, and glue adhesion, conform to the required specifications with no delamination or damage observed. The report concludes that the sample complies with the relevant standards as per the testing results.

Uploaded by

sunder kitply
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
75 views1 page

35MM FDSL

The In House Test Report evaluates a solid flush door by M/s. PLYWOOD CORPORATION for the NIFT project, confirming it meets IS:2202 (Part-1)/1999 standards. All tested parameters, including dimensions, squareness, flatness, and glue adhesion, conform to the required specifications with no delamination or damage observed. The report concludes that the sample complies with the relevant standards as per the testing results.

Uploaded by

sunder kitply
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

REF.NO.

KIL/BNG/2025-2026 DATED 09TH MAY 2025


In House Test Report of Solid Flush Door as per IS:2202(Part-1)/1999
Name of Distributor : M/s. PLYWOOD CORPORATION
Name of Contractor : M/s ARUDHI PROJECTS

Project Details : WORK SITE ADMIN BUILDING FOR NIFT AT HSR LAYOUT.
Door Specifications : 35mm thick Flush Door Shutter as per IS:2202 (Part-I)/1999, with teak
lipping single and double shutters.

S. No. Tests Requirement as per IS:2202 (Part – 1)/1999 Results


Tolerance:
Height -+5mm
Dimensions & Width -+5mm On nominal dimensions Conforms
1 Thickness -+1mm
Squareness
Variation in thickness between any two points not
Conforms
more than 0.8mm
General
2 Twist, Cupping & Warping not more than 6mm Conforms
Flatness
Local
3 Depth of deviation not greater than 0.5mm Conforms
Plainness
Glue Adhesion
4 No delamination No delamination
Test
Impact No cracking, tearing or delamination Conforms
5 Indentation
Test Depth of indentation <0.2mm Depth of indentation: 0.05mm
6 Slamming No visible damage after 50 drops No damage
7 Knife Test Minimum pass standard Pass standard
Screw Not less than 1000N 2560N
8 Withdrawal Surface Condition: No visible damage to the
Strength Conforms
surface either by delamination or chipping
No permanent deformation of the fixing or any part
9 Misuse Test of the door set hindering its normal working after Conforms
the test
End
10 Immersion No delamination No delamination
Test

Sample confirms to IS:2202 (Part-1)/1999


FOR KITPLY INDUSTRIES LTD

(AUTHORISED SIGNATORY)

Camscanner

You might also like