Architecture & Structural Engineering
Architecture & Structural Engineering / Quantities and Reports / Reporting / General Reports
Concrete Formwork Report
After the formwork scaffolding settings are made with the Concrete Formwork Report
command, the formwork scaffolding report is created.
Location of the Formwork Drawings Command
You can access it from the Reports tab under the Formwork heading.
Usage Steps
Click the Concrete Formwork Report icon. The concrete formwork report dialog will
open.
In the dialog that opens, the settings related to the formwork scaffolding will be
seen.
After making the necessary adjustments, click the Generate button.
ideCAD Report will run automatically and your selections will be created as
column/wall, beam and slab formwork scaffolding report on separate pages under
a single report.
Sample concrete formwork report pages
Formwork Scaffolding Settings
Specifications
Column primary section
The primary support beam section of the column formwork is selected from the list.
Column secondary section
The secondary support beam section of the column formwork is selected from the list.
Slab primary section
The primary support beam section of the slab formwork is selected from the list.
Slab secondary section
The secondary support beam section of the slab formwork is selected from the list.
Beam primary section
The primary support beam section of the beam formwork is selected from the list.
Beam secondary section
The secondary support beam section of the beam formwork is selected from the list.
Beam upper primary section
The primary upper support beam section of the beam formwork is selected from the
list.
Beam upper secondary section
The secondary upper support beam section of the beam formwork is selected from the
list.
Plywood thickness
Plywood plate thickness value is entered.
Rod diameter
The diameter value of the fitting (rod) is entered.
Wind load C
Wind load coefficient value is entered.
Wind load Q
Wind pressure value is entered.
Support H
A value is entered for the support settlement height.
Support V
A value is entered for the support settlement width.
Support interval
Value is entered for the support interval.
Strut axial load capacity
Support axial load capacity value is entered.
Modulus of elasticity
Modulus of elasticity value is entered separately for timber and plywood material.
Bending strength
The bending strength value is entered separately for timber and plywood material.
Shear strength
Shear strength value is entered separately for timber and plywood material.
Rod yield stress
Yield strength value is entered for rods.
Beam prop axial load capacity
Prop axial load capacity is entered for beam props.
Slab prop axial load capacity
Axial load capacity is entered for slab props.
Number of consecutive props, n
The number of consecutive prop is entered.
Concrete casting speed
The value in m/hour is entered for the concrete casting speed.
Concrete casting temperature
A value in °C is entered for the concrete casting temperature.
Whole project
Formwork scaffolding report is generated for the whole project.
Active story
Formwork scaffolding report is created for the active story.
Selected objects
Formwork scaffolding report is generated for the selected objects.
Next Topic
Getting Reports Based on Personnel
Related Topics
Analysis Settings Report
Concrete Design Settings Report
TBDY 2018 Seismic Parameters Report
EQ Code General Report
Column-Beam Joint Safety Report
ideCAD / Architectural / Structural / Download PDF
Copyright © 2025 © Copyright 1988 – 2024 ideYAPI • Powered by Scroll Viewport & Atlassian Confluence
