DDS W/S10 Btnchtop Conductivity Meter

introduction
Thank you for selecting the DDS-W or 5 series benchtop
conductivity meter, this product series includes 3 models
MODEL PARAMETERS

510 Conductivity/TDS/0C/0F

DDS-12DW Conductivity/0C/0F
This manual provides a step-by
DDS-307W step guide to help you operate these
Conductivity
meters, please carefully read the following instruction according to the
model you have purchased
MAHU*
Measurement mode indicator
UNPACKING THE METER. Indicates meter is in the measurement
modeenvironment meets
Before unpacking, ensure that the current work
Caftiwbon
following conditions
Calibration mode indicator
• Relative humidity is less than 80%
Indicates meter is in the calibration
• Ambient temperature is greater than 0OCmodeand less than 600C
• No potential electromagnetic interference
Setup mode indicator
Indicates meter
The following list descnbes the standard accessories of the is in SETUP
meter After
the unpacking, please check allS*up mode
accessories are complete If any ore
damaged or missing, please contact nearest distributor
Hold indicator
Hold
Indicates the displayed value has been
frozen

ACCESSORIES Automatic Temperature Compensation indicator

DDS-
MODEL 510 DDS-12DW 307W Keypad mode
Indicates meter is m the temperature compensation

Conductivity Elective • • • The meter has a succinct membrane keypad, names and symbols describe the each
Temperature Probe • • function key controls

Calibration Solutions • MODEL 510

Temperature Probe KEY FUNCTION
Power Adapter • • •
MEASlfi • Power the meter 0(WF
• Locks the measured value on the display, press the
key
again to resume measuring
• Exits the calibration or setting mode

MOOE • Toggles between conductivity and TDS modes

CAL Itt • Press the key to enter the calibration mode

• Press and hold the key to enter the setup menu
Conductivity Flectrode Temperature Probe

*C • Press the key to set or calibrate the temperature

▲ • Press the key to increase setting value

T • Press the key to decrease setting value

• Confirms the calibration setting value or displayed

ENTER
option

to show measured values mode indicators and help message The following
Display list descnbes the feature of each indicator
The metei is equipped with a clear end bright LCD display that is used
measured values, mode indicators and help message. The following 0
list describes the feature of each indicator. 2
EDMI