Scribd
Upload
43 views1 page

ASI BUS Gateway Trouble Shooting 3

The document is a troubleshooting guide for LED status displays related to power supply and communication in a gateway system. It outlines the meanings of different LED indicators, including power, configuration errors, and fieldbus connectivity. Additionally, it provides steps to diagnose issues based on LED status and suggests contacting manufacturers for specific control or fieldbus problems.

Uploaded by

edlistianto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
43 views1 page

ASI BUS Gateway Trouble Shooting 3

The document is a troubleshooting guide for LED status displays related to power supply and communication in a gateway system. It outlines the meanings of different LED indicators, including power, configuration errors, and fieldbus connectivity. Additionally, it provides steps to diagnose issues based on LED status and suggests contacting manufacturers for specific control or fieldbus problems.

Uploaded by

edlistianto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Troubleshooting Guide

LED Status Display


Green POWER LED: red CONFIG ERROR LED:
` off: Is the power supply connected? ` off: Everything is okay!
Is the ASi PWR plug connected to the gateway? ` on: What information is shown in the gateway display?
` on: Everything is okay!
No error can be detected based on the LED display, but your existing installation
Green U ASI LED: is in error condition?
` off: Is the correct power supply being used? 30 V power supplies  ` see chapter “Where can I get help?” 
Is a power fail or a short circuit on the ASi circuit detectable?
See chapter “General “Error Codes””  Note: The status LEDs do NOT indicate error messages. The green PRG ENABLE is on when automa-
` on: Everything is okay! tic addressing is enabled. During operation, the yellow PRJ MODE LED is off because the gateway is
operating in protected mode and is not configured.

Green ASI ACTIVE LED:


` off: Is ASi communication or the ASi Gateway active online Is a safety monitor installed?
` on: Everything is okay! Safety Monitor
green AUX LED:
FELDBUS LED: ` off: Is the power supply connected? Is the
` off: Is the fieldbus cable connected? Is the higher-level control switched on? 24V/0V plug plugged into the gateway?
Is the correct configuration of the fieldbus connection (IP address, etc.) and, if ` on: Everything is okay!
applicable, the GSD configuration available?
Note: In case of problems with the used control or the fieldbus, please contact directly the respec- yellow SI or SO LED:
tive manufacturer! ` off: no periphery connected.
` on: periphery connected!
Remark: An inactive fieldbus can be signaled e.g. at PROFINET Gateways by a red illuminated LED or
at a EtherNet/IP Gateway by a red flashing LED! Note: With 6-channel Safety Monitors, the following error messages can be displayed:
` all LEDs flash: Safety-Error/Fatal Error (see chapter “General “Error Codes”” )
` on (green): Everything is okay! ` single LED flashes: Is a cross-circuit or an overload at the output detectable?

You might also like