Scribd
Upload
44 views4 pages

32-Port Mirroring Configuration

The document provides a guide on configuring port mirroring for OLT management, detailing the commands needed to set up both source and destination ports for monitoring traffic. It includes steps to enter global configuration mode, configure mirroring settings, and save the configuration. Additionally, it outlines how to display the current port mirroring configuration information.

Uploaded by

fmorocoto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
44 views4 pages

32-Port Mirroring Configuration

The document provides a guide on configuring port mirroring for OLT management, detailing the commands needed to set up both source and destination ports for monitoring traffic. It includes steps to enter global configuration mode, configure mirroring settings, and save the configuration. Additionally, it outlines how to display the current port mirroring configuration information.

Uploaded by

fmorocoto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Port Mirroring Configuration

Table of Contents
Port Mirroring Configuration...................................................................................................................................... I
Table of Contents....................................................................................................................................................II
Chapter 1 Port Mirroring Configuration......................................................................................................................1
1.1 Configuring Port Mirroring Task.................................................................................................................. 1
1.1.1 Configuring port mirroring............................................................................................................... 1
1.1.2 Displaying port mirroring information................................................................................................1
Table of Contents

Chapter 1 Port Mirroring Configuration

1.1 Configuring Port Mirroring Task

1.1.1 Configuring port mirroring

In order to make OLT management easy, you can set port mirror and use a port of
the OLT to observe the flux that runs through a group of ports.

Enter the global configuration mode and set port mirroring according to the
following steps:

Command Purpose

config Enters the global configuration mode.

mirror session session_number destination Configures port mirroring destination port


interface interface-id [RSPAN vlan-id [tpid]]
session-number means the number of the port
mirroring.

interface-id means the mirroring destination


port, the uplink port.

RSPAN means remote mirroring.

vlan-id means the vlan ID of the remote


mirroring tag.

Tpid means the tag of remote mirroring.

mirror session session_number {destination Configures port mirroring source port.


interface interface-id [ rspan vid tpid] |
session-number means the number of the port
source interface {interface-id [, | -]}&<1-n>
mirroring.
[rx | tx | both ] }
interface-id means the mirroring source port,,
which can designate -multiple ports.

Both means the mirroring bidirectional packet,


the default is both.

Rx means the input data of mirroring.

Tx means the output data of mirroring.

exit Goes back to the EXEC mode.

write Saves the settings.

1.1.2 Displaying port mirroring information

To display the configuration information about port mirroring, run the following
command:

-1-
Table of Contents

Command Purpose

show mirror [session session_number] Displays the configuration information about


port mirroring session-number means the
number of the port mirroring.

-2-

You might also like