Scribd
Upload
104 views19 pages

Era ADS-B System Operation Training: Richard Xie

The document describes the overall architecture of an ADS-B system including ground stations, antennas, routers, and site monitors. Data flows from the GPS and antennas through receivers and computers to the site monitors and then to a central database. The document provides instructions for configuring, turning on and off, and using the different components of the ADS-B ground station system.

Uploaded by

muhammad arif sulaiman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
104 views19 pages

Era ADS-B System Operation Training: Richard Xie

The document describes the overall architecture of an ADS-B system including ground stations, antennas, routers, and site monitors. Data flows from the GPS and antennas through receivers and computers to the site monitors and then to a central database. The document provides instructions for configuring, turning on and off, and using the different components of the ADS-B ground station system.

Uploaded by

muhammad arif sulaiman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd

Era ADS-B System Operation Training

Richard Xie

March 2009
Overall Architecture

VSAT router

RCMS
VSAT
Network

LCMS LCMS LCMS LCMS

VSAT router VSAT router VSAT router


VSAT router

Rack router Rack router Rack router Rack router ADS-B


antenna

Gps
Site monitor Site monitor antenna

Ground Ground Ground Ground


station station station station

2
Ground Station Rack

Router

GS01

GS02

Two UPS units


3
One Ground Station
Connect Antenna RF Cable

GPS Module

RPU(Computer)

Measurement Unit

Receiver 1
Receiver 2 Power Module
4
Data Flow

GPS
RGU UTC
~
UTC time „WHEN“
Corrective data PC Time mark
104
ADS-B report via CAT 21
1 sec
Time mark
Time mark through
nominal clock
LCMS
Data stamped by
/
MU clock (TOA)
TOA
RCMS
1090MHz MU ~
RX
card „WHERE“

Nominal time MU
Oscil

RXS

5
Site Monitor (SQB)

6
Site Monitor Cable Spec

7
Squitter Data Transmission

8
Squitter Transmission Rate

9
SQB Tech Spec

10
SQB Tech Spec (continued)

11
SQB Configuration

12
Turn On the System

13
Turn Off System

Switch off power units


and UPS

14
System Parameter Configuration

 Config files are in RPU computers


 Remote Desktop to RPU
 Configure Station Name, SIC, SAC
 Configure Reference Point
 Configure Communication

15
Display Application

 Configuration to receive data

16
Map Setup

 Map Center
 Load a Map

17
Parameter Filter

18
SQB Configuration

19

You might also like