Zookeeper+ActiveMQ集群搭建(1)

• 修改zookeeper配置文件名,到zookeeper的conf目录下将zoo_sample.cfg文件改名为zoo.cfg

$ mv zoo_sample.cfg zoo.cfg

• 编辑zoo.cfg文件

$ vim zoo.cfg

# The number of milliseconds of each tick tickTime=2000 # The number of ticks that the initial # synchronization phase can take initLimit=10 # The number of ticks that can pass between # sending a request and getting an acknowledgement syncLimit=5 # the directory where the snapshot is stored. # do not use /tmp for storage, /tmp here is just # example sakes. #这个地方的目录地址改一下 dataDir=/usr/local/zookeeper-3.4.5/data #日志目录 dataLogDir=/usr/local/zookeeper-3.4.5/logs # the port at which the clients will connect clientPort=2181 # # Be sure to read the maintenance section of the # administrator guide before turning on autopurge. # # http://zookeeper.apache.org/doc/current/zookeeperAdmin.html#sc_maintenance # # The number of snapshots to retain in dataDir #autopurge.snapRetainCount=3 # Purge task interval in hours # Set to “0” to disable auto purge feature #autopurge.purgeInterval=1 #配置三个server server.0=192.168.192.130:2888:3888 server.1=192.168.192.131:2888:3888 server.2=192.168.192.134:2888:3888

• 在zookeeper-3.4.5目录下创建data文件夹和logs文件夹

$ cd /usr/local/zookeeper-3.4.5

$mkdir data

$mkdir logs

• 在三个虚拟机下的data文件夹下创建三个myid文件，并且三个文件里面分别写入0,1,2

$ cd /usr/local/zookeeper-3.4.5/data

#192.168.192.130下 vim myid 在文件里面写入0，保存退出 #192.168.192.131下 vim myid 在文件里面写入1，保存退出 #192.168.192.134下 vim myid 在文件里面写入2，保存退出

• 启动三个zookeeper

$ zkServer.sh start</