Scribd
Upload
55 views1 page

Tepat Teknik SDN BHD - Welded Cover

The document provides equations for calculating the required thickness of a welded cover. The thickness is calculated based on the cover's outside diameter, corrosion allowance, dead load, live load, external pressure, imposed load, design allowable stress, and joint efficiency. For the given values in the example, the required thickness is calculated as 12.0 mm.

Uploaded by

jirrsama
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
55 views1 page

Tepat Teknik SDN BHD - Welded Cover

The document provides equations for calculating the required thickness of a welded cover. The thickness is calculated based on the cover's outside diameter, corrosion allowance, dead load, live load, external pressure, imposed load, design allowable stress, and joint efficiency. For the given values in the example, the required thickness is calculated as 12.0 mm.

Uploaded by

jirrsama
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

TEPAT TEKNIK SDN BHD

WELDED COVER

3.0 WELDED COVER


Cover outside diameter, d Corrosion Allowance, C.A Dead Load, D L Live Load, L r External Pressure, P e Impose load on cover,P Design allowable stress,S Joint efficiency,E Required thickness, t = d* sqrt (CP/SE) + c.a = 970 * sqrt ( ( 0.33 * 0.0013 ) / ( 6.0 = 7.55 mm = 12.0 mm 173 * 1.0 )+ = = = = = = = = 970 6.0 0.43 1.0 0.5 1.33 173 1.0 mm mm kPa kPa kPa kPa N/mm 2 (seamless) (greater of (e)(1) and (e)(2) of appendix R

As construct thickness

You might also like