Scribd
Upload
404 views2 pages

Abstract of Step Down Transformer From 400v

This document describes the construction of a step-down transformer that reduces voltage from 300V to 40V. The transformer consists of two coils - a primary coil and secondary coil - wound on an insulating core made of thin iron strips coated with varnish. The primary coil receives 300V input voltage, which is then stepped down to 40V output voltage in the secondary coil through electromagnetic induction based on their winding ratio of 7.5:1. Step-down transformers are widely used to reduce high voltages to safer levels that electronic devices can operate on.

Uploaded by

parmeshwar11
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
404 views2 pages

Abstract of Step Down Transformer From 400v

This document describes the construction of a step-down transformer that reduces voltage from 300V to 40V. The transformer consists of two coils - a primary coil and secondary coil - wound on an insulating core made of thin iron strips coated with varnish. The primary coil receives 300V input voltage, which is then stepped down to 40V output voltage in the secondary coil through electromagnetic induction based on their winding ratio of 7.5:1. Step-down transformers are widely used to reduce high voltages to safer levels that electronic devices can operate on.

Uploaded by

parmeshwar11
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

ABSTRACT

CONSTRUCTION OF A STEP DOWN TRANSFORMER FROM 300V TO 40V


INTRODUCTION TO A STEP DOWN TRANSFORMER FROM 300V TO 40V
a step down transformer is explain as the alternating means of regulating down the voltage as the input 300V down to the low volt 40V, the output voltage. This transformer consist of two winding the primary winding and the secondary winding. A primary winding is used to up the voltage while a secondary winding of a transformer is use to step-down the voltage. The turn ratio is calculated corresponding to voltage ratio and is given as (N1N2)=(V1V2) we take 300v in primary(input) and 40v in secondary(output) side then the turn ratio will be 300:40 =7.5:1

Construction:
The transformer consists of two coils. They are insulated with each other by insulated material and wound on a common core. For operation at low frequency, we may have a soft iron. The soft iron core is insulating by joining thin iron strips coated with varnish to insulate them to reduce energy losses by eddy currents. The input circuit is called primary. And the output circuit is called secondary. The aim of the project is the voltage from 300v to40v as the output.
SCOPE OF THE PROJECT

Step-down transformer is widely known for reducing of voltage from the high voltage to low and much use when the voltage is higher than the power of the appliance connect to of and then reduce down to the normal voltage of the appliance.

SUBMITTED TO Mr. DEEPJAYOTI SUBMITTED BY


PARMESHWAR LAL ASHISH SHARMA ANIL SAINI

(guided by Mr.

SANDEEP SHARMA)

You might also like