Scribd
Upload
371 views1 page

Calibration Frequency

This document outlines the calibration frequency and calibration agency for 41 different measuring equipment used at Aurangabad Electrical Ltd-Plant-IX. The calibration frequency ranges from every 10 days to every 3 years depending on the equipment. Most equipment is calibrated internally but some are calibrated externally. A few pieces of equipment have additional remarks about calibration frequency.

Uploaded by

smallik3
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
371 views1 page

Calibration Frequency

This document outlines the calibration frequency and calibration agency for 41 different measuring equipment used at Aurangabad Electrical Ltd-Plant-IX. The calibration frequency ranges from every 10 days to every 3 years depending on the equipment. Most equipment is calibrated internally but some are calibrated externally. A few pieces of equipment have additional remarks about calibration frequency.

Uploaded by

smallik3
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 1

AURANGABAD ELECTRICAL LTD-PLANT-IX CALIBRATION FREQUENCY OF MEASURING EQUIPMENT Sr.No.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 Remark:

Format No: 10/M/03 Date:- 22.05.2012

Description
Micrometer(Analog) Micrometer(Digital) Mic('V' mic) Mic(P-Mic) Vernier Caliper Vernier Caliper(0-600mm) Dial Indicator Height Gauge Thread Plug Gauges Thread Ring Gauges(GO) Thread Ring Gauges(NOGO) Snap Gauge Sleeve Gauge Socket Gauge Bore Gauge Check Plug Gauge Wear Check Plug Gauge Torque Wrench Slip Gauge Set 3-Wire Set Surface Plate Profile Projector Bevel Protector V'- Block Plating Thickness Tester Torque Wrench Hardness Tester UTM Dewinter Microscope Spectrometer Max Voltmeter Ammeter Pressure gauge Temp.controller Temp.controller Thermocouple Sensor Tempering Furnace Hardening Furnace Dacro Oven pH Meter Digital conductivity meter Timer Digital

Freq.Of Cal.
3 Months 1 Year 2 Year 1 Year 3 Months 1 Year 3 Months 3 Months 15 Days 10 Days 15 Days 3 Months 10 Days 3 Months 1 Year 2 Year 1 Year 1 Year 1 Year 1 Year 1 Year 3 Year 1 Year 1 Year 2 Year 1 Year 1 Year 1 Year 1 Year After 100 spark 1 Year 1 Year 1 Year 1 Year 3 Months 1 Year 1 Year 1 Year 1 Year 1 Year 1 Year 1 Year

Cal.Agency
Internal External External External Internal External Internal Internal Internal Internal Internal Internal Internal Internal External External External External External External External External External External External External External External External Internal External External External External External External External External External External External External

Remark

Two time in months Three time in months Two time in months Three time in months

Heat Treatment Location

Prepared by: BHOKARE

Approved by:

You might also like