Scribd
Upload
821 views2 pages

Lab #07 Full Wave Bridge Inverter

An inverter converts DC power from a source like a battery into AC power by using a full wave bridge circuit. The circuit uses four diodes arranged in a bridge configuration to convert the DC voltage from the source into a quasi-sinusoidal AC voltage waveform at its output. However, a pure sine wave is not produced using this basic inverter technique commonly found in UPS battery backup systems.

Uploaded by

Asad Malik
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
821 views2 pages

Lab #07 Full Wave Bridge Inverter

An inverter converts DC power from a source like a battery into AC power by using a full wave bridge circuit. The circuit uses four diodes arranged in a bridge configuration to convert the DC voltage from the source into a quasi-sinusoidal AC voltage waveform at its output. However, a pure sine wave is not produced using this basic inverter technique commonly found in UPS battery backup systems.

Uploaded by

Asad Malik
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Inverter

Lab #07 Full Wave Bridge Inverter

Introduction:
Inverter is used to convert DC source into AC source to some extent. This technique is used in UPS used frequently in homes today. Pure sine wave is not achievable through this technique.

Circuit Diagram:

Inverter

Source Waveform:

Output voltage:

Output current:

You might also like