Scribd
Upload
70 views16 pages

Tito Villaluna John Reantaso Jepp Ilagan Darryl Lam

This document provides specifications for existing components of an evaporator cooling system, including: 1) The evaporator coils are installed inside a water tank and use refrigerant to cool the water. Coils come in lengths of 50, 100, or 150 feet with an outside diameter of 1/2 inch typically. 2) Additional details are provided on the specifications of the compressor, including voltage, BTU capacity, and operating conditions. 3) Specifications are listed for the condenser coils, fins, fans, and various sensors and gauges that are part of the cooling system.

Uploaded by

John Reantaso
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
70 views16 pages

Tito Villaluna John Reantaso Jepp Ilagan Darryl Lam

This document provides specifications for existing components of an evaporator cooling system, including: 1) The evaporator coils are installed inside a water tank and use refrigerant to cool the water. Coils come in lengths of 50, 100, or 150 feet with an outside diameter of 1/2 inch typically. 2) Additional details are provided on the specifications of the compressor, including voltage, BTU capacity, and operating conditions. 3) Specifications are listed for the condenser coils, fins, fans, and various sensors and gauges that are part of the cooling system.

Uploaded by

John Reantaso
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 16

Tito Villaluna

John Reantaso
Jepp Ilagan
Darryl Lam
Existing Components

Evaporator
The evaporator coils are installed inside the water tank
wherein the water is then cooled by the refrigerant
passing in the coil.

The commercially available length is 50, 100 and 150

The ideal O.D. (Outside diameter) for a cooling coil of
chilled water tank is .
The fins are made of aluminum. The standard
thickness of aluminum fins 0.0075. We can use
0.0095 for higher quality. However, it is also possible
to use 0.006 for less cost.

The casing of a evaporator is usually galvanized steel.
However, for chilled water coils, it is usually stainless
steel.
Coatings is usually made if its 3-5 miles of the ocean
where corrosion might be a factor.


Compressor
The specification of the compressor:

230V 60Hz
BTU capacity: 5400
Phase : 1

Maximum operating condition:
Suction pressure: 114psig
Discharge temperature: 240 F
Discharge pressure: 377psig
Return gas pressure: 95 F
Motor winding temperature: 265

Tube Specifications

- 5/8" O.D. x .020" wall thickness standard
with optional wall thickness of (.025) (.035)
and (.049).

Fin Specifications

-5/8" tubes comes standard with
aluminum fin .008" thick with
optional (.010).

Condenser Fan Specification

RPM-950, Capacitor-7.5uFC/400V AC
Current: 1.21A
Insulation-Class B
Voltage -230V
Frequency -60Hz
Horsepower: 1HP
Poles: 6
Phase: Single (1)
Inside look
From the
outside
Condenser fan blower
Ammeter and voltmeter
Low and high pressure gauge
Thermometer

Flow meter

You might also like