Scribd
Upload
55 views2 pages

KNL2383 Electronic Circuits - Tutorial 1, Semester 2 2014/2015

This document contains a tutorial on electronic circuits with 4 questions: 1) Determine various voltage and current values for a circuit given in Figure 1. 2) Determine the input and output currents and voltages for the network in Figure 2. 3) Calculate the current I for a Zener constant-current source shown in Figure 3. 4) Design a BJT LED driver circuit that applies a 5V input to power an LED requiring 10mA based on Figure 4. Standard resistor values should be used.

Uploaded by

Bong Kuek Kong
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
55 views2 pages

KNL2383 Electronic Circuits - Tutorial 1, Semester 2 2014/2015

This document contains a tutorial on electronic circuits with 4 questions: 1) Determine various voltage and current values for a circuit given in Figure 1. 2) Determine the input and output currents and voltages for the network in Figure 2. 3) Calculate the current I for a Zener constant-current source shown in Figure 3. 4) Design a BJT LED driver circuit that applies a 5V input to power an LED requiring 10mA based on Figure 4. Standard resistor values should be used.

Uploaded by

Bong Kuek Kong
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

KNL2383 Electronic Circuits Tutorial 1, Semester 2 2014/2015

Instruction: Answer all questions. Handwritten answers has to be neatly presented.


Marks would be deducted if the presentation is not satisfactory.
1.

Given the information appearing in Figure 1, determine:


(i)

IC

(ii) VE

(iii) VCC (iv) VCE (v) VB

(vi) R1

VCC
IC

2.7 k

R1

10.6V

20 A

VCE

VB
8.2 k

100

1.2 k

Figure 1

2.

For the network of Figure 2, determine:


(i) IE

(ii) VC

(iii) VCE
8V
2.2 k

VCE

VC

IE
1.8k

10 V
Figure 2

Dr Andrew Lakshmanan, Dept. of Electrical and Electronics, Faculty of Engineering, UNIMAS.

KNL2383 Electronic Circuits Tutorial 1, Semester 2 2014/2015

3.

A Zener constant-current source is shown in Figure 3. Calculate the current I.

I
200

1.5 k

5.1V

1.2 k

12V

Figure 3

4.

The circuit shown in Figure 4 is a BJT LED driver. Design the driver when a 5V DC is applied to
the input. Assume that the LED requires about 10mA for full brightness with a voltage of
1.8Vacorss it. Use standard values of resistors.

VCC 10 V
IC

RC

LED
5V
0

RB

Vo 10 V

IB

VCE

min 50

Figure 4

Dr Andrew Lakshmanan, Dept. of Electrical and Electronics, Faculty of Engineering, UNIMAS.

You might also like