Scribd
Upload
62 views

2K6 Ec 307 (P) : Basic Electronics Lab: Sessional Work Assessment

This document outlines the experiments and topics covered in a basic electronics lab course. The course involves 3 hours of practical work per week. Key topics covered include series and parallel resonant circuits, diode and Zener diode characteristics, filter circuits using resistors and capacitors, clipping and clamping circuits, rectifier circuits, voltage regulators, transistor characteristics, and determination of transistor parameters. Student work is assessed based on lab practicals and a test, with sessional marks totaling 50. References for the course include books on basic electronics circuits and devices. University evaluation of the course involves assessment of student lab procedures, diagrams, calculations, results and record.

Uploaded by

Joseph John
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
62 views

2K6 Ec 307 (P) : Basic Electronics Lab: Sessional Work Assessment

This document outlines the experiments and topics covered in a basic electronics lab course. The course involves 3 hours of practical work per week. Key topics covered include series and parallel resonant circuits, diode and Zener diode characteristics, filter circuits using resistors and capacitors, clipping and clamping circuits, rectifier circuits, voltage regulators, transistor characteristics, and determination of transistor parameters. Student work is assessed based on lab practicals and a test, with sessional marks totaling 50. References for the course include books on basic electronics circuits and devices. University evaluation of the course involves assessment of student lab procedures, diagrams, calculations, results and record.

Uploaded by

Joseph John
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2K6 EC 307(P) : BASIC ELECTRONICS LAB

3 hours Practical per week

1.

Series resonant and parallel resonant circuits - voltage and current amplification

2.

Diode & Zener diode characteristics - dc and dynamic resistance

3.

Constant -k low pass and high pass filters

4.

First and second order LPF/HPF/BPF with R and C for a given cut-off frequency

5.

Clipping circuits with diodes

6.

Clamping circuits & voltage multipliers

7.

Half wave rectifier with C, LC & CRC filters

8.

Full wave rectifiers with C, LC & CRC filters

9.

Zener diode regulator with emitter follower output - regulation curves

10. UJT characteristics & the relaxation oscillator


11. CB configuration - determination of h parameters
12. CE configuration - determination of h parameters
13. MOSFET characteristics in CS and CD modes
Sessional work assessment
Lab Practicals and Record
Test
Total marks

= 30
= 20
= 50

Reference books
1.Bhargava et.al., Basic Electronic Circuits and Linear Circuits, Tata McGraw Hill
2. Boylestead & Nashelski, Electronic Devices and Circuit Theory, 9th Ed, Pearson/PHI
3. Millman & Halkias, Integrated Electronics, Tata McGraw Hill

University evaluation will be for 100 marks of which 70 marks are allotted for writing the
procedure/formulae/sample calculation details, preparing the circuit diagram/algorithm/flow chart, conduct
of experiment, tabulation, plotting of required graphs, results, inference etc., as per the requirement of the
lab experiments, 20 marks for the viva-voce and 10 marks for the lab record.
Note: Duly certified lab record must be submitted at the time of examination

You might also like