Scribd
Upload
886 views3 pages

Experiment 1 Breadboard Implementation

This document describes an experiment using a breadboard to implement a circuit that causes LEDs to flash in a dancing pattern. The objectives are to understand how to use a breadboard and become familiar with common components. A breadboard allows easy testing of circuits before permanent implementation on a circuit board. It describes the materials used, including integrated circuits, resistors, capacitors and LEDs. The circuit diagram shows an LED flashing circuit built around a decade counter/divider and timer IC. Connecting the circuit to a power supply causes the LEDs to light up in a dancing pattern.

Uploaded by

Jeremy Lorenzo Teodoro Virata
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
886 views3 pages

Experiment 1 Breadboard Implementation

This document describes an experiment using a breadboard to implement a circuit that causes LEDs to flash in a dancing pattern. The objectives are to understand how to use a breadboard and become familiar with common components. A breadboard allows easy testing of circuits before permanent implementation on a circuit board. It describes the materials used, including integrated circuits, resistors, capacitors and LEDs. The circuit diagram shows an LED flashing circuit built around a decade counter/divider and timer IC. Connecting the circuit to a power supply causes the LEDs to light up in a dancing pattern.

Uploaded by

Jeremy Lorenzo Teodoro Virata
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Experiment no.

Breadboard
Implementation
I.

OBJECTIVES

II.

To understand how to implement circuits using Breadboard


To familiarize with the different components used

DISCUSSION
A Breadboard or a Protoboard or Plug-board is a testing board used for
testing of circuits before implementing them permanently on PCB. It is a
simple plastic board which is wired from inside in a particular manner and you
can test circuit comprising of IC's, resistors, capacitors and many other pin
devices by just plugging it inside the holes provided. Breadboard are
reusable, you can do as many implementations as you want.

III.

MATERIALS & EQUIPMENT

CD4017 decade counter/divider

1pc

NE555 timer IC

1pc

LED Superbright (blue)

8pcs

SPST switch

1pc

DC Power Supply

1set

10 k resistor watt

1pc

IV.

100 k potentiometer

1pc

10 F electrolytic capacitor

1pc

220 resistor watt

8pc

CIRCUIT DIAGRAM

Fig 1.1 Dancing LED circuit

V.

PROCEDURE

Connect the circuit as illustrated in Fig 1.1 on your Breadboard.

Connect your Breadboard to DC supply adjusted to 9V.

VI.

DATA & RESULTS

What happened to the LEDs in your circuit?


______________________________________________________________________
______________________________________________________________________

You might also like