Scribd
Upload
81 views8 pages

Adamson University College of Engineering Electronics Engineering Department 1 SEMESTER / S. Y. 2015-2016

This document contains instructions for an electronics engineering laboratory experiment on discrete and continuous time signal generation. Students are asked to generate four different types of signals and waveforms using MATLAB based on their assigned terminal number: 1) A sinusoidal signal in continuous time and its discrete time equivalent using Nyquist rate, 2) An exponential decay signal, 3) An exponentially growing signal, and 4) An amplitude modulated signal. The signals are to be generated for analysis in signal processing and systems.

Uploaded by

Aileen May Santillan Herrera
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
81 views8 pages

Adamson University College of Engineering Electronics Engineering Department 1 SEMESTER / S. Y. 2015-2016

This document contains instructions for an electronics engineering laboratory experiment on discrete and continuous time signal generation. Students are asked to generate four different types of signals and waveforms using MATLAB based on their assigned terminal number: 1) A sinusoidal signal in continuous time and its discrete time equivalent using Nyquist rate, 2) An exponential decay signal, 3) An exponentially growing signal, and 4) An amplitude modulated signal. The signals are to be generated for analysis in signal processing and systems.

Uploaded by

Aileen May Santillan Herrera
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

ADAMSON UNIVERSITY

COLLEGE OF ENGINEERING
ELECTRONICS ENGINEERING DEPARTMENT
1ST SEMESTER / S. Y. 2015-2016

EXPERIMENT TITLE

Discrete and Continuous Time Signal Generation

EXERCISE NUMBER

COURSE CODE

ECE328L

SECTION/SCHEDULE

59034 / WEDNESDAY 2:00-5:00

NAME:

Herrera, Aileen May S.

I.

Using MATLAB commands, generate the following waveforms or signals used in


Signal processing and systems: Use your terminal number for all values of TN.
Use value of n equal to your TN multiplied by 10 and should be an integer.
a. Sinusoidal signal (10pts)
V(t) = 10cos150t volts and
V[n] from converting V(t) to discrete time signal using Nyquist rate.(fs=2fa)
where fa= analog frequency content of signal.
Use V[n]=10cos2(fa/fs)n

b.
Y[n] = 10 e-(TN+TNj)n where TN=terminal number
c.
A[n] = TNe10TN
d.
VAM = [1+(10/100)sin2(TN/100)n]sin2(10/100)n (10points)

You might also like