Scribd
Upload
29 views2 pages

Lab Pap

This document contains 12 multiple choice and short answer questions about electronics concepts such as voltage dividers, series RL and RC circuits, current and resistance calculations, components of an AC circuit including resonance, using simulation software, waveform properties, circuit elements that oppose voltage changes, using a CRO to determine frequency, identifying diode terminals, determining resistance values, and building a full wave rectifier circuit.

Uploaded by

Nina Butt
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
29 views2 pages

Lab Pap

This document contains 12 multiple choice and short answer questions about electronics concepts such as voltage dividers, series RL and RC circuits, current and resistance calculations, components of an AC circuit including resonance, using simulation software, waveform properties, circuit elements that oppose voltage changes, using a CRO to determine frequency, identifying diode terminals, determining resistance values, and building a full wave rectifier circuit.

Uploaded by

Nina Butt
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

1. Certain voltage divider consists of two 12 k resistors in series.

Which of the following


load resistors will have the most effect on the output voltage?
A. 1 M
B. 24 k
C. 18 k
D. 12 k
2. To increase the current in a series RL circuit, the frequency
A. should be increased
B. should be decreased
C. should be constant
D. cannot be determined without values
3. When the frequency of the voltage applied to a series RC circuit is decreased, the
impedance
A. decreases
B. increases
C. does not change
D. cannot be determined without values
4. Approximately how many milliamperes of current flow through a circuit with a 40 V
source and 6.8 k of resistance?
A. 27.2 mA
B. 59 mA
C. 5.9 mA
D. 590 mA
5. A 200 resistor, a coil with 30 of reactance, and a capacitor of unknown reactance are
in series across an ac source. The circuit is at resonance. Circuit impedance
A. is 230
B. is 170
C. is 200
D. cannot be determined
6.
A.
B.
C.
D.

While doing Simulation on Proteus, you can pick components from


Top toolbar
Side toolbar
Bottom toolbar
No-one

7. If we have Square wave of Vp-p=10volts then what would be its Vrms

A.
B.
C.
D.

4.67 volts
5 volts
10volts
No-one

8.
A.
B.
C.
D.

Which of the following component opposes the change in circuit voltage


Resistor
Capacitor
Inductor
No-one

9. If on CRO screen number of divisions covered are 6 along x-axis and time/div is selected
to be 5ms then what would be frequency .?? [2marks]
________________________________________________________________________
________________________________________________________________________
________________________________________________________________________
_______
10. Identify cathode and anode in given diode.[2marks]

11. Determine resistance value .[2marks]

12. If You want to build fullwave rectifier then show connection diagram using given bread
board. [2marks]

You might also like