Scribd
Upload
73 views3 pages

Heart-Shaped Badge Project: Parts Required

This document describes a heart-shaped badge project that uses eight LEDs arranged in the shape of a heart. One LED lights up at a time in a chasing pattern around the heart shape. The badge uses a 555 timer circuit to provide clock pulses to a 4017 counter IC to control which LED is lit. It requires various resistors, capacitors, ICs, switches, and a battery to power an 8 LED circuit arranged on a small stripboard badge connected by ribbon cable to the main circuit board.

Uploaded by

Jojo Abrogina
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
73 views3 pages

Heart-Shaped Badge Project: Parts Required

This document describes a heart-shaped badge project that uses eight LEDs arranged in the shape of a heart. One LED lights up at a time in a chasing pattern around the heart shape. The badge uses a 555 timer circuit to provide clock pulses to a 4017 counter IC to control which LED is lit. It requires various resistors, capacitors, ICs, switches, and a battery to power an 8 LED circuit arranged on a small stripboard badge connected by ribbon cable to the main circuit board.

Uploaded by

Jojo Abrogina
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

Heart-shaped Badge Project

NOTE: PWEDE NATING IBAHIN UNG ARRANGEMENT NG LEDS

The badge consists of eight LEDs arranged in the shape of a heart. One LED is lit at a
time and this 'chases' round the shape. It would be easy to adapt this project to create
other shapes with the eight LEDs. This project uses a 555 astable circuit to provide the
clock pulses for the 4017 counter.

Parts Required

• resistors: 2.2k, 47k, 270 ×8


• capacitors: 0.1µF, 1µF 16V radial
• red LEDs ×8
• 555 timer IC
• 4017 counter IC
• DIL sockets for ICs: 8-pin, 16-pin
• on/off switch
• battery clip for 9V PP3
• safety pin to attach badge
• ribbon cable 9-way about 1 metre (to connect badge to main circuit)
• stripboard: 16 rows × 19 holes for circuit, 10 rows × 9 holes for badge

Stripboard Layouts
Circuit diagram

You might also like