Scribd
Upload
76 views2 pages

About RAM

RAM is a form of computer memory that allows any memory cell to be accessed directly through its row and column address. Unlike sequential access memory (SAM) which accesses cells sequentially, RAM provides random access. The basic unit of RAM is a memory cell consisting of a transistor and capacitor that holds a bit of data as an electrical charge. However, the capacitor leaks so the memory controller must periodically refresh all cells to prevent data loss, giving dynamic RAM its name.

Uploaded by

camjass
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
76 views2 pages

About RAM

RAM is a form of computer memory that allows any memory cell to be accessed directly through its row and column address. Unlike sequential access memory (SAM) which accesses cells sequentially, RAM provides random access. The basic unit of RAM is a memory cell consisting of a transistor and capacitor that holds a bit of data as an electrical charge. However, the capacitor leaks so the memory controller must periodically refresh all cells to prevent data loss, giving dynamic RAM its name.

Uploaded by

camjass
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

RAM Random Access Memory

RAM is the best known form of computer memory and easy to upgrade. Random access memory (RAM) is the best known form of computer memory. RAM is considered "random access" because you can access any memory cell directly if you know the row and column that intersect at that cell. The opposite of RAM is serial access memory (SAM). SAM stores data as a series of memory cells that can only be accessed sequentially (like a cassette tape). If the data is not in the current location, each memory cell is checked until the needed data is found. SAM works very well for memory buffers, where the data is normally stored in the order in which it will be used (a good example is the texture buffer memory on a video card). RAM data, on the other hand, can be accessed in any order. Similar to a microprocessor, a memory chip is an integrated circuit (IC) made of millions of transistors and capacitors. In the most common form of computer memory, dynamic random access memory (DRAM), a transistor and a capacitor are paired to create a memory cell, which represents a single bit of data. The capacitor holds the bit of information -- a 0 or a 1 (see How Bits and Bytes Work for information on bits). The transistor acts as a switch that lets the control circuitry on the memory chip read the capacitor or change its state. A capacitor is like a small bucket that is able to store electrons. To store a 1 in the memory cell, the bucket is filled with electrons. To store a 0, it is emptied. The problem with the capacitor's bucket is that it has a leak. In a matter of a few milliseconds a full bucket becomes empty. Therefore, for dynamic memory to work, either the CPU or the memory controller has to come along and recharge all of the capacitors holding a 1 before they discharge. To do this, the memory controller reads the memory and then writes it right back. This refresh operation happens automatically thousands of times per second.

The capacitor in a dynamic RAM memory cell is like a leaky bucket. It needs to be refreshed periodically or it will discharge to 0.

This refresh operation is where dynamic RAM gets its name. Dynamic RAM has to be dynamically refreshed all of the time or it forgets what it is holding. The downside of all of this refreshing is that it takes time and slows down the memory.

You might also like