Scribd
Upload
81 views1 page

Pine Tree Print

The origami pine tree instructions begin with folding a square piece of paper in half twice to create center creases. The top three corners are then folded down to the bottom corner and flattened. Each triangular flap is folded toward the center crease, unfolded, and then the flap is opened and flattened. Once all four flaps are folded in this way, the full color top flap is exposed and the model is folded along the center crease and unfolded. Finally, each full color flap is folded backwards underneath itself to form the pine tree shape.

Uploaded by

Balaji Sundararajan
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
81 views1 page

Pine Tree Print

The origami pine tree instructions begin with folding a square piece of paper in half twice to create center creases. The top three corners are then folded down to the bottom corner and flattened. Each triangular flap is folded toward the center crease, unfolded, and then the flap is opened and flattened. Once all four flaps are folded in this way, the full color top flap is exposed and the model is folded along the center crease and unfolded. Finally, each full color flap is folded backwards underneath itself to form the pine tree shape.

Uploaded by

Balaji Sundararajan
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Origami Pine Tree

www.origami-fun.com

1. Start with a square piece of paper, coloured side up. Fold the paper in half, crease well and open, and then fold again in the other direction

2. Turn the paper over to the white side. Fold the paper in half, crease well and open, and then fold again in the other direction. Your creases should look like this.

3. Using the creases you have made, Bring the top 3 corners of the model down to the bottom corner. Flatten model.

4. Fold toward centre line and unfold.

5. Using the crease you have just made, open and flatten this flap.

6. Repeat step 4 and 5 on the other 3 flaps of the model.

7. Now make sure there are equal flaps underneath the model, and that the top flap is showing full color, like this.

8. Fold whole model along this crease and unfold

9. Fold each full colour flap backwards underneath itself.

10. Now you can adjust your pine tree so it is even all the way around, and it stands up by itself!

You might also like