Scribd
Upload
516 views1 page

Machine Drawing Series 1 Question Paper

The document is a mechanical engineering drawing exam from St. Thomas Institute for Science and Technology in Thiruvananthapuram, India. It contains two parts: Part A involves sketching locking arrangements for nuts and foundation bolts, as well as drawing a double riveted lap joint. Part B involves drawing front and top views of a solid object based on a pictorial view. The exam tests students' machine drawing skills and ability to draw various mechanical components and views within the allotted 3 hour time period.

Uploaded by

Kailas Sree Chandran
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
516 views1 page

Machine Drawing Series 1 Question Paper

The document is a mechanical engineering drawing exam from St. Thomas Institute for Science and Technology in Thiruvananthapuram, India. It contains two parts: Part A involves sketching locking arrangements for nuts and foundation bolts, as well as drawing a double riveted lap joint. Part B involves drawing front and top views of a solid object based on a pictorial view. The exam tests students' machine drawing skills and ability to draw various mechanical components and views within the allotted 3 hour time period.

Uploaded by

Kailas Sree Chandran
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ST.

THOMAS INSTITUTE FOR SCIENCE AND TECHNOLOGY


THIRUVANANTHAPURAM
Class No: .. Name : .. CONTINUOUS ASSESSMENT EXAMINATION I, AUGUST 2012 THIRD SEMESTER MECHANICAL 08.306 ENGINEERING DRAWING (Part A and Part B are to be answered in separate answer books) Time: 3 hours PART A MACHINE DRAWING Max. Marks: 50
PART I (Answer any two questions)

1. Sketch any two locking arrangement of nuts for bolt shank diameter 16mm. 2. Sketch any two foundation bolts for bolt shank dia of 20mm. 3. Draw a double riveted zig-zag lap joint for plates of thickness 12mm. (2 x 10 marks= 20 marks)
PART II

4. Draw the following views of the solid shown in the pictorial view given below. a. Front view in the direction of arrow. b. Top view (30 marks)

Page 1 of 2

You might also like