BioLite CampStove Instruction Manual
BioLite CampStove Instruction Manual
instruction manual
This stove is intended to burn solid biomass only. Never add liquids, gels, plastics, or other accelerants into stove. Metal surfaces will be hot when stove is operating and present a burn hazard.
Thank
BioLite.CampStove.
The information contained in this instruction manual as well as videos to help clarify operation are available on our website.
http://www.biolitestove.com/support
for product and service inquiries, contact:
you
for
purchasing
Not designed for use in heavy rain. Keep Power Module dry. Follow all local fuel collection and remaking regulations. Cooking and re policies vary from season to season and park to park. Only you can prevent forest res.
CampStove
at home
BEFORE FIRST USE OF THIS PRODUCT, please follow the instructions below on how to charge the rechargeable lithium-ion battery. Like a car, your BioLite CampStove contains a battery to aid in easy startup. Before rst use, it is recommended that you charge the battery with an external power source. If the stove is unused for more than six months, repeat these steps to ensure your stoves battery is properly charged.
start up
Note: fuel refers to solid biomass, e.g. wood, pine cones, etc., never use liquid fuels or charcoal.
1
Fire-building suggestions
1. Using the included double ended USB cable, connect the USB port on the CampStoves Power Module to a USB charging port (on a computer, laptop, USB wall charger, etc). 2. The light around the USB port on the Power Module will ash orange while charging. 3. The light will stop ashing and become solid orange when the battery is ready for rst use. (May take up to 2 hours.)
1. Slide Power Module probe into stove body side. There will be a gap between the Power module and the body. This gap is intentional and is not meant to be sealed. 2. Fully extend all legs to lock Power Module in place. 3. Place on level ground away from any overhanging branches. Clear away dry brush on the ground around the stove. Have water handy in case of accident. 4. Place small, loose, and dry fuel in Fuel Chamber. See right for suggestions on restarting. 5. Light the fuel. Use a long match or the included relighters to aid in safe relighting. 6. After ten seconds, push Power Button to start fan. (This sets fan to LO to start oxygen ow.) If fan turns off, push Power Button again.
Recommended fuels for best res: Tinder: dried twig shavings, birch bark Kindling: dry twigs (e.g. evergreen) Use relighters to aid in restarting Dry, dense fuels will burn hottest and longest (e.g. oak, maple, r, birch) Arrangement Break twigs to t. Crisscross dry twigs above the tinder and kindling. Loosely ll Stove Chamber. Avoid blocking the jets on the side of the chamber. Avoid using wet or damp wood or leaves. These will smoke excessively and burn poorly.
NOTE
run
1. As re builds, add larger dry fuel. At this point, you can push Power Button to HI. (This sets fan to HI to increase oxygen ow.) 2. Use Power Button to toggle between LO and HI to optimize re. The fan indicator light will glow green when set to HI, and orange when set to LO. While the fan has the ability to greatly increase re efciency, the high setting can blow out a weak ame. When starting the re or restarting the re from embers, use the LO fan setting. As the re grows to a roar, use the HI fan setting. To cool down re to simmer, use the LO fan setting. 3. At peak operation, the stove can be packed to the top with fuel.
CAUTION
touch here not here
cook
1. Place pot directly onto stove Pot Stand. The pot should be placed so the pot handle is aligned with a Pot Stand support so ames do not heat the handle. 2. During cooking, remove pot carefully and add dry fuel as needed. 3. To simmer, let re burn down. Push Power Button to return fan to LO.
NOTE
1. Charging capability is ready when the bar light around the USB port glows green. The bar light above the USB will glow orange when USB is not ready, and green when USB is ready. 2. Attach your devices charging cable to the USB port. Power output varies with the strength of your re. For maximum output, maintain a well-fueled re with fan set to HI. Some devices charge continuously. Other devices, like smartphones, will charge in regular NOTE intervals of boosted The CampStove supports power output. charging the following:*
Cell phones Smartphones MP3 Players LED Flashlights Headlamps Rechargable Batteries
charge
Metal Surfaces will be hot. While stove is hot or running, only touch plastic parts.
To avoid damage to the Power Module, ensure that it is never downwind of the ame.
X
!
WARNING
1. Allow re to burn down to cold ash. For live embers, pour into a dugout hole, extinguish with water, and cover with dirt. 2. The Power Module will turn off automatically as the stove cools. To manually power 3C off, hold Power Button for three seconds. After a manual turn off, the fan may automatically turn back on to keep the Power 3B Module cool and protected from the residual heat. 3A 3. To store the stove after the Fuel Chamber is cool, A. Fold legs down. B. Remove Power Module. C. Slide Power Module into Fuel Chamber.
shut down
&
tips+troubleshooting
1. Use dry fuel whenever possible. 2. For hottest and most efcient re, make sure that there is space between the pieces of wood, the holes on the side of the Fuel Chamber are not blocked, and all wood is entirely inside Fuel Chamber. 3. To avoid excessive smoking, use small twigs to restart a re from embers. Problem
USB not charging (orange bar light)
Cause
Insufcient re Battery not charged
Solution
Add more fuel to re. Add more fuel to re to charge battery. Check cable connection. Unplug cable on both ends and try again.
Exercise extreme caution when moving pot or adding fuel as pot and its contents are hot. As the pot is placed on the stove, ames may bend around the pot and present a burn hazard.
WARNING
WARNING
Unplug cable on both ends. Hold power button for 3 seconds and wait for the Power Module to automatically turn back on. When charging capability restores, replug cable. If problem persists, contact BioLite. Battery not charged (if ashing light)
When plugging and unplugging devices, do so carefully and without touching any metal surfaces as they can burn you. Keep devices away from ames and protected from spills.
To protect the stoves components, never pour water into the stove. When dumping embers, remember to extinguish and bury embers because live embers can start res!
Charge battery by plugging Power Module USB connection to computer. Contact BioLite.
operating
instructions
specications
Weight Fire Power Output (peak): USB Power Output: Pot Weight Limit: 2 lbs. 1 oz. / 935 grams 3.4 kW [lo mode] 5.5 kW [hi mode] 2W @ 5V [max continuous] 4W @ 5V [peak] 8 lbs or 1 gallon of liquid
! DANGER
CARBON MONOXIDE, EXPLOSION, FIRE, BURN, & CORROSION HAZARD CARBON MONOXIDE HAZARD. This stove is for OUTDOOR USE ONLY, never for use in tents, vehicles, indoors, or other places without fresh air. Carbon Monoxide inhalation can cause death or brain damage. Carbon Monoxide (CO) is produced when fuel burns. EXPLOSION - FIRE HAZARD. This stove is intended to burn solid biomass (e.g. wood, pinecones, etc) only. NEVER add liquids, gels, plastics, or other accelerants into stove. This stove is hot during use and can ignite ammable materials too close to the ame. Keep ammable materials at least 18 inches from the sides and 48 inches from the top of the stove. Keep gasoline and other ammable liquids and vapors well away from the stove. Clean stove frequently to avoid grease accumulation and possible grease res. Never leave stove unattended. BURN HAZARD. Metal surfaces on stove will be hot when stove is operating and present a burn hazard. Handle stove by Power Module only. Flames may be large. Never leave stove unattended when hot or in use. Do not move stove while lit. Keep out of reach of children. Always use on level ground. BATTERY HAZARD. The rechargeable battery inside the power module may present a risk of re, explosion, leakage or chemical burn if mishandled. To prevent hazards, keep power module dry to preclude corrosion of the battery. Keep power module and battery well away from other heat sources. Do not expose the battery to excessive physical shock, pressure, or vibration. DO NOT attempt to change the battery yourself. If the battery does not recharge, please contact BioLite for repair information. READ, UNDERSTAND, AND FOLLOW ALL instructions and warnings in this manual before operating this stove. Failure to comply with the precautions and instructions provided with these stoves can result in property loss or damage, serious bodily injury, or death. Only persons who can understand and follow the instructions should use this stove. Contact BioLite with any questions about safety or operation.
Power Module
maintenance
Orange Plastic Power Module Remove from stove body and wipe down with a damp cloth with soap and water. DO NOT submerge in water or allow to get excessively wet.
cleaning
Power Button LOW/HI Fan Indicator Lights USB Indicator Light USB Charging Port USB Drop Cover Folding Legs Double-ended USB cable (for startup battery charging)
Stainless Steel Stove Body Clean out all ash and scrub with nylon brush. Dishwasher safe. Dry thoroughly.
Keep CampStove in a cool, dry, and well-ventilated place. Avoid storage in excessive heat. Keep out of reach of children
storage
If stove is stored for more than six months, the battery may need to be recharged. Follow the instructions in Step 0 to charge your battery.