MEphisto Scope 1 V1.
1
Block Diagram
*
Kanal A
(256 kS)
Kanal B
WerteSpeicher
USB-Anschluss (Typ B)
26polige Sub-D Buchse
Prozessor-Steuerung
Interner Daten-/Steuer-Bus
Ext. Trigger
24 bits
Digital I/O-Teil
USBInterface
MEphisto Scope 1
Features
acquisition modes
voltmeter, DC
voltmeter, true RMS
analog oscilloscope
analog oscilloscope, stand alone
analog data logger
analog data logger, stand alone
logic analyzer
logic analyzer, stand alone
digital data logger
digital data logger, stand alone
mass storage
real time clock
UM202
UM203
SD card
up to 2 GB
Technical Data
Voltmeter Mode
analog channels
resolution
non linearity, integral
sampling rate
simultaneous channels
voltage range (in 1-2-5 steps)
analog bandwidth (-3dB) DC
RMS
accuracy (voltage) at 25C / 77F
accuracy (time)
overvoltage protection
noise (typ.)
input impedance
2
16 Bit
2 LSB
2 x 1 Sps
2
100mV to 10V
40 kHz
2.3 kHz
0.1% or 1mV
100 ppm
300VDC
-94dB (RMS)
-86dB (P-P)
1 M, 14 pF
Analog Oscilloscope Mode
analog channels
resolution
non linearity, integral
sampling rate
sampling memory per channel
simultaneous channels
voltage range (in 1-2-5 steps)
analog bandwidth (-3dB)
automatic signal recognition
voltage range
frequency range
duty cycle, square wave, 100 Hz, 100 mVpp
time base
(1s/S to 10ms/S in 1s steps,
above this range 10ms/S steps)
accuracy (voltage) at 25C / 77F
accuracy (time)
overvoltage protection
noise (typ.)
input impedance
trigger modes
level
window
edge
dV/dt
manual
extern
delay
2
16 Bit
2 LSB
2 x 1 MSps
100 samples to
131000 samples
2
100mV to 10V
500 kHz
50mVpp 20Vpp
0.2Hz 500kHz
0.2% - 99.8%
1s to 2.5s
0.1% or 1mV
100 ppm
300VDC
-66dB (RMS)
-48dB (P-P)
1 M, 14pF
6
Logic Analyzer Mode
digital channels
simultaneous channels
sampling memory per channel
simultaneous trigger channels
sampling rate
delay between the 8 bit groups
time base
(10s/S to 10ms/S in 1s steps
above this range 10ms/S steps)
accuracy (time)
logic level
16
8+8
100 samples to
262000 samples
8
100 kSps
2 s
10s to 2.5s
100 ppm
5V CMOS
(1.8V/3.3V CMOS;
12V/24V;
with optional converter)
overvoltage protection
input impedance
trigger modes
pattern (low / high / edge rising / edge falling / ignore)
in any combination simultaneous for the lower 8 bit
manual
extern
delay
+5.5VDC/-0.5VDC
50 M, 8 pF
4
Analog Data Logger Mode
analog channels
resolution
nonlinearity, integral
sampling rate
simultaneous channels
voltage range (in 1-2-5 steps)
analog bandwidth (-3dB)
time base
(10s/S to 10ms/S in 1s steps
above this range 10ms/S steps)
accuracy (voltage) at 25C / 77F
accuracy (time)
overvoltage protection
noise (typ.)
input impedance
trigger modes
level
window
edge
dV/dt
manual
extern
delay
2
16 Bit
2 LSB
2 x 100 kSps
2
100mV to 10V
500 kHz
10s to 2.5s
0.1% or 1mV
100 ppm
300VDC
-66dB (RMS)
-48dB (P-P)
1 M, 14 pF
6
Digital Data Logger Mode
digital channels
simultaneous channels
simultaneous trigger channels
sampling rate
USB
SD card
delay between the 8 bit groups
time base
(10s/S to 10ms/S in 1s steps
above this range 10ms/S steps)
accuracy (time)
logic level
16
8+8
8
100 kSps
2.5 kSps
2 s
10s to 2.5s (USB)
400s to 2.5s (SD)
100 ppm
5V CMOS
(1.8V/3.3V CMOS;
12V/24V;
with optional converter)
overvoltage protection
input impedance
trigger modes
pattern (low / high / edge rising / edge falling / ignore)
in any combination simultaneous for the lower 8 bit
manual
extern
delay
GPIO Mode (not available in logic analyzer mode)
digital channels
resolution
direction programmable individually for each bit
read back function for outputs
logic level
+5.5VDC/-0.5VDC
50 M, 8 pF
4
24
1 Bit
5V CMOS
Device Data
sample memory
interface
512 kB
USB 2.0 (FS),
USB1.1 compatible
power supply
5V via USB,
5V via external
power supply
(UM203 only)
maximum power consumption,
no load on digital channels
connectors
analog channels
digital channels
USB
external power supply (UM203 only)
SD card (UM203 only)
dimensions
case
including connectors
weight
operating temperature
storage temperature
0.9W *)
2 * BNC
1 * SUB-D-26 (HD)
USB B
DC plug, 5.5mm
push-push slot
112 x 110 x 32 mm
4.41 x 4.33 x 1.26 in
138 x 110 x 35 mm
5.43 x 4.33 x 1.38 in
430 g
0.95 lb
15 oz
070C
32..158F
-2085C
-4..185F
To ensure reliability with heavy load on the digital port, the device announces to have a power consumption
of 2.5W with the operating system inquiry. Therefore it might not be activated when connected to a passive
USB hub.
*)
System Requirements
Application
MEphisto Lab
CPU class
RAM
Windows XP
Windows Vista
hard disk
graphics
installation
interface
operating system
drivers only
CPU class
RAM
hard disk
interface
operating system
stand alone (UM203)
configuration process
PC
running acquisition
power supply
mass storage
minimal
Pentium III, 500MHz
recommended
Pentium IV, 2.4GHz
128MB
512MB
700MB (FAT32),
400MB (NTFS)
1024x768 pixel (XGA),
256 colors (8Bit)
256MB 1GB
1GB 4GB
1GB
64k colors (16Bit)
1024x768 pixel (XGA)
to
2048x1536 pixel (QXGA)
CD ROM drive
CD ROM drive
+ internet
USB 1.1
USB 1.1 USB 2.0
Windows 2000
Windows 2000
Windows XP
Windows Vista
minimal
recommended
80486, 100MHz
Pentium II, 200MHz
32MB
128MB
ca. 5MB
USB 1.1
USB 1.1 USB 2.0
Windows 2000
Windows XP
Windows Vista
without support:
Windows 98SE
Windows Me
Linux
Mac OS-X
recommended
depending on application
refer to either MEphistoLab or driver section
5VDC, > 250mA / > 1.3W
standard SD card, 8 MB up to 2 GB
