Scribd
Upload
130 views1 page

RCD Problem

The document provides specifications for designing reinforcement for a cantilever beam with a 6m span. The beam carries a dead load of 25 kN/m and a live load of 43.5 kN/m. It has a width of 350mm, total depth of 770mm, and steel coverings of 70mm at the top and bottom. The concrete strength is 28MPa and steel yield strength is 420MPa.

Uploaded by

Ricci Marcelo Ü
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
130 views1 page

RCD Problem

The document provides specifications for designing reinforcement for a cantilever beam with a 6m span. The beam carries a dead load of 25 kN/m and a live load of 43.5 kN/m. It has a width of 350mm, total depth of 770mm, and steel coverings of 70mm at the top and bottom. The concrete strength is 28MPa and steel yield strength is 420MPa.

Uploaded by

Ricci Marcelo Ü
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Design the reinforcement for a cantilever beam with a span of 6m that carries a dead load (including its

own weight) of 25 kN/m and a live load of 43.5 kN/m. The beam has a width of 350mm and a total depth
of 770mm. The steel covering to centroid of reinforcement is 70mm at top and bottom. fc'=28MPa,
fy=420MPa, dmBolt=36mm (Use pmax for comparison).

Given:

DL=

LL=

A concrete beam

You might also like