Camshaft Oil Hole Testing Device
Camshaft Oil Hole Testing Device
International Journal Of Research Publications In Engineering And Technology [IJRPET]
ISSN: 2454-7875
Special Issue , Sept. 2015
Cam Shaft Oil Hole Testing Gadget
Dhawale Mahesh Balkrishna
TY AE Marathwada Mitra Mandal’s Polytechnic, Pune/MSBTE Maharashtra India
UNDER THE GUIDANCE OF
Prof. Kurhade A.S.
Department Of Automobile Engineering Marathwada Mitra Mandal’s Polytechnic, Pune/MSBTE
Maharashtra India
Abstract
In this project we focus on quality checking of product. From older day the cam shaft
checking is done by very simple method, they use one small metal rod. Which is smaller in
diameter compared to oil hole diameter of camshaft is inserted in oil hole and another is
inserting in hole which are provided on general hole, which is perpendicular to the axis of
shaft. When both rod are touch to each other then quality checking person know the hole is
incorrect. This project established new way idea of product checking in advance.
Introduction List of equipment
Quality control consist of all those • Camshaft.
activity’s , which are to design to define • V-Block
, maintain and control specific quality of
• Proximity Sensor
product within reasonable limits .it is
the systematic regulation of all variable • Air Pipe
affecting goodness of the end product. It • Air Nozzle.
does not attempt to achieve the perfect
• Indicating Lamps.
quality but to secure satisfactory or
reasonable quality at a competitive level.
Project: -
Project Cost
“CAM SHAFT OIL HOLE • Project cost up to Rs- 10,000/-.
TESTING GADGET”
1|Page
International Journal Of Research Publications In Engineering And Technology [IJRPET]
ISSN: 2454-7875
Special Issue , Sept. 2015
Working Future Scope
The main concept of this project is
quality checking of camshaft. As per This equipment is useful for
shown in construction diagram. The cam camshaft producing company.
shaft which is to be checked is placed on
v-block then sensor is actuated and sends Use in the automobile company who
the signal to the valve. Then valve is buy from the camshaft from vender
opened start air is supply. company.
When air supply starts it passes through
the oil hole of a camshaft also passes on
general surface of camshaft. When air References
delivered from oil hole it strike on sheet
www.historytv18.com
metal plate. At the same time sensor
www.discoveryscience.com
sense the moment of plate and give
www.goggle.com
signal on board. By this method
camshaft can be checked. If the camshaft
is not ok that means oil hole are not in
correct position.
Advantages
It takes less time to check the
camshaft.
To improve quality checking
It avoids rejection.
Lees maintenance
DISADVATAGES
It more costly.
2|Page
