Scribd
Upload
43 views1 page

1.3.4 Indicators: Output Power: (Max. Average Power at 1 KHZ With 0.5% Ce 1000 Stereo: 275 W/Channel Into 8 Ohms, 450 W

This document describes the indicators and power output specifications for a CE 1000 amplifier. It has green LEDs that flash for low level audio signals and turn on for power. A red LED turns on for audio clipping. A red FAULT LED blinks under 5 conditions including overheating. The amplifier outputs 275W per channel into 8 ohms or 900W in bridged mono mode.

Uploaded by

Sebastian Conde
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
43 views1 page

1.3.4 Indicators: Output Power: (Max. Average Power at 1 KHZ With 0.5% Ce 1000 Stereo: 275 W/Channel Into 8 Ohms, 450 W

This document describes the indicators and power output specifications for a CE 1000 amplifier. It has green LEDs that flash for low level audio signals and turn on for power. A red LED turns on for audio clipping. A red FAULT LED blinks under 5 conditions including overheating. The amplifier outputs 275W per channel into 8 ohms or 900W in bridged mono mode.

Uploaded by

Sebastian Conde
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

1.3.

4 Indicators
A green LED SIGNAL indicator for each channel, which
flashes when a very low level signal (>–40 dBm) is present
at input.
A red LED CLIP indicator for each channel, which turns on
when distortion becomes audible in the amplifier output.
A red FAULT indicator, which will blink under 5 different
conditions:
1. When the amplifier is first powered up, until the unit
is ready for operation.
2. If the heatsinks reach a temperature above normal
working limits.
3. If the transformer thermal protection circuit is activated.
4. If the load on the amplifier develops a short- circuit.
5. Should the amplifier ouput stage become non-operational.

A green LED POWER indicator that turns on when the amplifier


has been turned on and has power.

1.3.2 Power
Output Power: (Max. average power at 1 kHz with 0.5%
THD.)
CE 1000 Stereo: 275 W/channel into 8 ohms, 450 W/
channel into 4 ohms, 560 W/channel into 2 ohms,
both channels driven.
CE 1000 Bridged Mono: 900 W into 8 ohms, 1100 W
into 4 ohms.

You might also like