INTERNATIONAL ISO
STANDARD 10042
En 30042
Second edition
2005-41-15
Welding — Arc-welded joints in
aluminium and its alloys — Quality levels
for imperfections
Soudage — Assemblages en aluminium et alliages o'aluminium soudés
Jaro — Niveaux de qualité par rapport aux défauts
Reference number
180 10042:2005(E) sJSO/18042:2006(E)
POF disclaimer
‘This POF file may coniain embedded typefaces. In accordance with Adobe's lensing polity, this file may be printed of viewed but
‘Shall not be euiled! unless the typefaces which are embedded are licensed to and installed on the computer performing the editing, In
ownloading ths fle, pares accept therein the responsibilty of ret infanging Adobe's Icensing policy. The ISO Cential Secretariat
ecepts no labilly inthis area,
‘gobe ts a traclemark of Adobe Systems Incorporated
Details of the somtware produets used to cfeale this PDF file can be found In the General Info relatwe to the Nie: the PDF-creation
paramsters were optimized for printing. Evary care has been taken to ensure thal the fle is suable for use by ISO member bodies. In
the unikely event that 2 problem relating to i's found, please inform the Central Secretariat atthe acdress given below
© 1802005
All nights reserved. Uniess otherwise specified, no part of this publication may be reproduced or ubized in any form or by any means,
flecttonis or mechanical, including photocopying and microti, without permission in wiling from ether ISO at the address below oF
180s member body inthe country of the requester
180 copyright office
(Gace postale 56 » CH-1211 Geneva 20
Tel +4122 7490111
Fax +41 22 749000 47
E-mail
[email protected]
‘Web wn iso 01g
Punished in Swzertand 1SO 10042:2005(E)
Contents Page
Foreword.
Introduction
Scope
Normative references
Terms and definitions.
‘Symbols
Assessment of imperfections..
aeons
Annex A (informative) Examples of the determination of the percent porosity
Annex B (informative) Additional information and guidelines for users of this International
Standard
ography.
