Scribd
Upload
90 views1 page

Corrosion Specification

This document provides coating specifications for DCS100 coating system to be applied to external surfaces of equipment exposed to non-corrosive indoor and outdoor conditions. The 3-step process includes abrasive blast cleaning of the surface, followed by application of a single pack etch primer at 15-25 micrometers, an alkyd universal undercoat at 20-30 micrometers, and a high gloss alkyd enamel final coat at 25-30 micrometers for a total dry film thickness of 60-85 micrometers. Safety precautions and manufacturer recommendations must be followed for aspects not covered in the specifications.

Uploaded by

madodandembe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
90 views1 page

Corrosion Specification

This document provides coating specifications for DCS100 coating system to be applied to external surfaces of equipment exposed to non-corrosive indoor and outdoor conditions. The 3-step process includes abrasive blast cleaning of the surface, followed by application of a single pack etch primer at 15-25 micrometers, an alkyd universal undercoat at 20-30 micrometers, and a high gloss alkyd enamel final coat at 25-30 micrometers for a total dry film thickness of 60-85 micrometers. Safety precautions and manufacturer recommendations must be followed for aspects not covered in the specifications.

Uploaded by

madodandembe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

LDEC-802-TS

CLIENT PROJECT No 4600011380


Technical Specification
ATTACHMENT REVISION PAGE

D 6 1

18. DETAILED COATING SPECIFICATIONS

COATING SYSTEM DCS100


APPLICATION CONDITIONS:
Normal environment
Ferritic substrate below 70°C
(This specification applies to the painting of all items exposed to non-corrosive indoor and outdoor
conditions, namely, external surfaces of gearboxes, pumps, valves, air receivers, compressors and
piping (refer to detailed list for specifics)

PROCESS: ACTIVITY DFT


SURFACE PREPARATION: Abrasive blast-clean to Grade Sa 2,5 (ISO
8501-1).

PRIMER COAT Apply by brush, airless spray or dipping, one 15 to 25 micrometres


coat Single Pack Etch Primer.

UNDERCOAT: After allowing sufficient time for the primer 20 to 30 micrometres.


coat to dry, apply by brush or airless spray,
one coat of Alkyd Universal Undercoat.

FINAL COAT: After allowing sufficient time for the 25 to 30 micrometres


undercoat coat to dry, apply one coat of High
Gloss Alkyd Enamel.

Total dry film thickness of coating system: 60 to 85 micrometres

GENERAL: After installation, lining up, grouting etc., all


damage shall be repaired and coatings made
good to the Engineer’s approval.

ADDITIONAL NOTES:

With respect to aspects not mentioned in the Detailed Coating Specification (e.g. overcoating and
curing times, mixing ratios, pot life, thinning, safety precautions etc.), the manufacturer’s
recommendations shall be strictly adhered to (refer to specific Product and Material Safety Data
Sheets).
SAFETY NOTE:
The manufacturer’s recommendations regarding the safe handling and use of these materials shall be
adhered to.
Please consult the Material Safety Data Sheets for detail.
RECOMMENDED / APPROVED SUPPLIERS AND/OR PRODUCTS:

The following manufacturers and/or suppliers are recommended / approved based on results gained
through tests and experiences.

Any SABS approved supplier or products tested and accepted for use by a reputable testing facility.

ALTERNATIVE PRODUCTS WHICH MAY QUALIFY:


(Please contact the Engineer for latest test results)

You might also like