Lightsabers
Lightsaber Instructions
1. Print at 100% (do not scale down) and cut out the hilt you want to use.
2. For Yoda’s lightsaber shoto: Glue or tape hilt around an empty toilet paper roll.
3. For the generic Jedi’s lightsaber: Glue or tape hilt around an empty paper towel roll.
4. For Darth Maul’s double-bladed lightsaber: Use clear tape or duct tape to connect two paper towel rolls end to end.
Then glue or tape hilt around the connected paper towel rolls.
STAR WARS™ and © 2012 Lucasfilm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.
YODA’S LIGHTSABER
GLUE
BEAM END
HANDLE
STAR WARS™ and © 2012 Lucasfilm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.
JEDI’S LIGHTSABER
BEAM END
GLUE
HANDLE
STAR WARS™ and © 2012 Lucasfilm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.
DARTH MAUL’S DOUBLE-BLADED LIGHTSABER (1 of 2)
CONNECT WITH OTHER END
GLUE
BEAM END
STAR WARS™ and © 2012 Lucasfilm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.
DARTH MAUL’S DOUBLE-BLADED LIGHTSABER (2 of 2)
CONNECT WITH OTHER END
GLUE
BEAM END
STAR WARS™ and © 2012 Lucasfilm Ltd. All rights reserved. Used under authorization. © 2012 Microsoft Corporation. All rights reserved. Reproduction permitted solely for personal and noncommercial use.
